Kenwood TK-3131 Instruction Manual - Page 20
Setting Mode.
UPC - 019048136329
View all Kenwood TK-3131 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
5 Press the PTT, MON, or CAL key to exit Setting Mode. To begin scanning: 1 Press and hold the v key for 1 second. • appears on the display. 2 When a signal is detected and the QT/ DQT matches, the channel number appears on the display and blinks. 3 When the signal is no longer present, the transceiver waits for 5 seconds before scanning continues. • If a new signal appears before the 5 seconds elapse, the transceiver will remain on the channel until the new signal is no longer present, at which time it will again wait for 5 seconds before continuing. 4 To end the scan at any time, press and hold the v key for 1 second. • The transceiver returns to the channel you were using before you started scanning. 14
14
5
Press the
PTT
,
MON
, or
CAL
key to exit
Setting Mode.
To begin scanning:
1
Press and hold the
▲
key for 1 second.
•
appears on the display.
2
When a signal is detected and the QT/ DQT
matches, the channel number appears on the
display and blinks.
3
When the signal is no longer present, the
transceiver waits for 5 seconds before
scanning continues.
•
If a new signal appears before the 5 seconds
elapse, the transceiver will remain on the
channel until the new signal is no longer
present, at which time it will again wait for
5 seconds before continuing.
4
To end the scan at any time, press and hold
the
▲
key for 1 second.
•
The transceiver returns to the channel you
were using before you started scanning.