Kenwood VR-5080 User Manual 1 - Page 39
Connecting the Antennas, AM Loop Antenna, What if I Have Cable Radio?, RF Remote Antenna
View all Kenwood VR-5080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Connections Chapter One : Connecting Your Devices RF Remote Antenna Connecting the Antennas FM Indoor Antenna AM Loop Antenna RF REMOTE ANTENNA The Remote Control unit for the VR-5700/VR-5090/ VR-5080 communicates with the receiver via RF transmission. To properly receive the RF remote signal, connect the provided RF Remote Antenna as described below. 1. Insert the jack of the provided RF Remote Antenna into the receiver's RF REMOTE ANTENNA jack. 2. Distribute the antenna wire horizontally and fix it. Distribute the antenna away from the metallic panel. FM 75Ω AM GND ANTENNA Your new receiver also comes with an FM indoor antenna for FM radio reception. To connect the FM antenna: 1. Attach the antenna sheath to the pole in the center of the receiver's FM antenna jack, as shown above. When you attach the sheath for the first time, you may need to exert quite a bit of pressure. 2. Adjust the antenna as necessary to improve reception. 3. Tack the looped end of the antenna in the location that provides the best reception. FM Outdoor Antenna FM 75Ω AM GND ANTENNA Kenwood recommends a permanently installed outdoor FM antenna for best FM reception. To connect an outdoor FM antenna: 1. Connect the antenna wire to a standard, commercially available antenna adapter as shown above. 2. Connect the adapter to the receiver's FM antenna jack. FM 75Ω AM GND ANTENNA 33 Your new receiver comes with an AM loop antenna for AM radio reception. To connect the AM antenna: 1. Insert the antenna loop into the base and position the loop. 2. Open the receiver's antenna terminal levers. 3. Insert the antenna's wires into the terminal as shown above. 4. Close the antenna terminal levers to lock the wires in place. 5. Adjust the antenna loop as necessary to improve recep- tion. To prevent hum interference, keep the AM antenna wires away from speaker wires, AC power cords, the TV chassis, and the receiver. What if I Have Cable Radio? If you have cable radio, contact your cable provider for assistance with connecting to the VR-5700/VR-5090/VR-5080.