Kenwood VR-5700 User Manual 1 - Page 47
Complete, Extend1, Error, Waiting, ClrFFExit, Video1, FMenu
View all Kenwood VR-5700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Chapter Two : Setting Up the Remote Control Unit Remote Setup 1 Press the Exit button (LCD function button 2) to exit from the operation. Press the Clr (clear) button (LCD function button 1) if you want to clear the previously programmed remote control signal and reset to the factory shipment condition. (Cleared is displayed.) 4. To program remote control signal, place the two units opposite to each as shown below. On the Remote Control unit of the selected device, press the button transmitting the desired remote control signal. Complete is displayed when the remote control signal has been programmed in this Remote Control unit. 4 inches (10cm) Complete Extend1 • "Error" is displayed when it failed. Error Extend1 2WAY LCD REMOTE CONTROL UNIT + + - - /8 1 /7 1 2 3 4 5 6 7 8 9 +10 0 +100 10 11 12 To change the remote control signal from a Remote Control unit button (When you select "Nothing" in step 8 on page 39): 1. Select the controlled device (CD, DVD, etc.) by pressing the MUSIC, MOVIE oRErCTV button. Video1 DVD FFFFFFMenu 2. Press the LEARN button. /8 1 /7 1 2 3 4 5 6 7 8 9 +10 0 +100 10 11 12 3. On the Remote Control unit, press the button you want to change the function. Waiting 1 1 4. On the Remote Control unit of the selected device, press the button transmitting the desired remote control signal. Complete is displayed when the remote control signal has been programmed in this Remote Control unit. REC Complete 5. To program other remote control signals, repeat steps 1 to 4 for each. To reset a button to the factory shipment condition by clear- ing the previously programmed signal: 41 Press the Clr button in step 3 of the procedure above. (Cleared is displayed) The remote control signal activated by holding the F.SHIFT button cannot be modified. /8 1 /7 1 2 3 4 5 6 7 8 9 +10 0 +100 10 11 12 5. To program other remote control signals, repeat steps 1 to 4 for each. ClrFFExit example: REPEAT Press the Exit button (LCD function button 2) to exit from the operation. "REPEAT" function cannot be modified. In programming a remote control signal, be sure to use the Remote Control unit originally provided with the AV device.