Kenwood VR-606 User Manual - Page 17
Operations, Normal playback, Listening to a source component, Preparing for playback
View all Kenwood VR-606 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Normal playback Preparing for playback Some preparatory steps are needed before starting playback. SPEAKERS POWER ON/OFF ON/STANDBY Listening to a source component VOLUME CONTROL AUTO INPUT MODE INPUT SELECTOR Turning on the receiver 1 Turn on the power to the related components. 2 Turn on the power to this receiver by pressing POWER ON/ STANDBY key. INPUT SELECTOR INPUT SELECTOR VOLUME + / - Selecting the input mode If you have selected a component connected to the CD/DVD, VIDEO 2 or DVD/6CH jacks, make sure that the input mode setting is correct for the type of audio signal to be used. 7 Selecting MD/TAPE Select the source name corresponding to the component connected to the MD/TAPE jacks. The initial factory setting is "TAPE". To change the source to "MD", follow the steps below: 1 Use the INPUT SELECTOR knob to select "TAPE". 2 Hold down the AUTO key for more than 2 seconds. • The source indication changes to "MD". • To return to the original indication, repeat procedure 2. Setting the speaker status The speaker indicator lights up. 1Use the INPUT SELECTOR knob or keys to select the source you want to listen to. The input sources change as shown below: Selecting a source using the INPUT SELECTOR knob. 1 "AUX" 2 "TUNER" 3 "CD/DVD" 4 "TAPE" or "MD" 5 "VIDEO 1" 6 "VIDEO 2" 7 "DVD/6CH" 2Start playback from the selected source. 3Use the VOLUME CONTROL knob or VOLUME +/- keys to adjust the volume. Press the SPEAKERS ON/OFF key to switch the speakers ON or OFF. 17 EN