KitchenAid KBBL306EPA Installation Guide - Page 23

6. Reverse or rotate the door stop to the desired position as shown below. NOTE: For Overlay Series models, rout the hinge side of the custom door panels to a radius that is equal to at least half the thickness of the panel if a 130° door swing is desired. 130° 110° Install Base Grille There are two pieces to the base grille to allow for a custom fit: the base grille itself and the skirt. The skirt can be added to the base grille in order to extend it all the way to the floor. 1. To see whether the skirt is needed, place the base grille into position. Do not attach the base grille to the refrigerator. Measure the distance between the bottom of the base grille and the floor. The gap must be a minimum of ¹⁄₂" (1.27 cm) in order to add the skirt. NOTE: If the gap measures less than ¹⁄₂" (1.27 cm), skip steps 3 and 4 of the instructions, and install the base grille only. 2. Remove the film from the base grille. 3. Snap the skirt onto the base grille. 90° 90° Left-hand as shown; Right-hand reversed 7. Replace the door stop screws and tighten. 8. Check that the door can open freely. Install Side Panel If the built-in area depth is 25" (63.5 cm) or more, the side panels can be installed inside the side trim or attached to the outside of the side trim. IMPORTANT: KitchenAid is not responsible for the removal or addition of molding or decorative panels that would not allow access to the refrigerator for service. 1. For the inside side trim piece, slide the front edge of the routed side panel into the trim piece. 2. Nail the rear edge of the panel to the support board. A A B A. Base grille B. Skirt 4. Trim the skirt by scoring the proper "V" groove with a utility knife. Break the skirt at the score line. A A. "V" groove 5. Using the two screws, attach the base grille assembly to the refrigerator as shown. NOTE: Drive in the right side screw first. B A. Support board B. Side trim piece A A. Screws (2) 23