KitchenAid KBFN502ESS Dimension Guide - Page 1

KitchenAid KBFN502ESS Manual

Get KitchenAid KBFN502ESS PDF manuals and user guides View all KitchenAid KBFN502ESS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 1 highlights

Side by Side Built-In Refrigerator PRODUCT MODEL NUMBERS KSSC36FT KSSC36QT KSSC42FT KSSC42QT KSSC42QV KSSC48FT KSSC48QT KSSC48QV KSSO36FT KSSO36QT KSSO42FT KSSO42QT KSSO48FT KSSO48QT KSSS36FT KSSS36QT KSSS42FT KSSS42QT KSSS48FT KSSS48QT Electrical: A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. A grounded 3 prong electrical outlet should be placed within 4" (10.2 cm) of the right side cabinets or end panel. Water Supply: A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about your water pressure, call a licensed, qualified plumber. IMPORTANT: If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure coming out of the reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 30 and 120 psi (207 and 827 kPa). The water shutoff should be located in the base cabinet on either side of the refrigerator or some other easily accessible area. If the water shutoff valve is not in the cabinets, the plumbing for the water line can come through the floor or the back wall. Location: Do not install the refrigerator near an oven, radiator, or other heat source, or in a location where the temperature will fall below 55°F (13°C). Floor must support the refrigerator weight, more that 600 lbs (272 kg), door panels and contents of the refrigerator. OPENING DIMENSIONS To avoid tipping during use, the solid soffit must be within 1" (2.5 cm) maximum above the refrigerator. If the solid soffit is higher than 1" (2.5 cm) or one isnot available, then the refrigerator must be braced. If the anti-tip boards are needed, they must be attached to the rear wall studs 80" to 90" (203 cm to 229 cm) above the floor. See "Install Anti-Tip Boards" for more information. NOTE: A clearance of 1⁄2" (1.3 cm) above the top grille must be maintained in order for the top grille to be removed. IMPORTANT: s Flooring under refrigerator must be at same level as the room. Face of cabinetry must be plumb. s The width of the opening (Width A), must be as specified for your model, for at least 2" (5.08 cm) back from the face of the cabinet. If your opening does not meet this requirement, you will need to make modifications. PRODUCT DIMENSIONS s The power cord is 84" (213 cm) long. s The line attached to the back of the refrigerator is 5 ft. (1.5 m) long. s Width dimensions were measured from trim edge to trim edge. s The depth from the front of the top grille to the back of the refrigerator cabinet is 25 3⁄8" (64.5 cm). s Height dimensions are shown with leveling legs extended 1⁄8" (3mm) below the rollers. SIDE VIEW 25³⁄₈" (64.5 cm) 23¹⁄₂" (59.7 cm) *83³⁄₈" (211.8 cm) 84" (213.4 cm) Power Cord 80" - 90" (203-229 cm) B Dimension 83¹⁄₂" (212.1 cm) min. 84³⁄₄" (215 cm) max. to bottom of solid soffit 77" (196 cm) A Width (see chart following) Width A Model (as shown) Width A for Overlay Models Dimension B (as shown) (as shown) 36 35 ¹⁄₂" to 35 ³⁄₄" 35³⁄₄" to 36" 4" (10.2 cm) (90.2 cm to (90.8 cm to 90.8 cm) 91.4 cm) 42 41 ¹⁄₂" to 41 ³⁄₄" 41³⁄₄" to 42" 10" (25.4 cm) (105.4 cm to (106 cm to 106 cm) 106.7 cm) 48 47 ¹⁄₂" to 47 ³⁄₄" 47³⁄₄" to 48" 16" (40.6 cm) (120.7 cm to (121.3 cm to 121.3 cm) 121.9 cm) 6" (15.2 cm) *3¹⁄₂" (8.9 cm) *When leveling legs are fully extended to 11⁄4" (3.2 cm) below rollers, add 11⁄8" (2.9 cm) to the height dimensions. TOP VIEW A 25³⁄₈" (64.5 cm) 1" 6" (2.54 cm) (15.2 cm) 24" (60.96 cm) min. 6" (15.2 cm) Model 36 42 48 Width A 35" (88.9 cm) 41" (104.1 cm) 47" (119.4 cm) Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation our products, we reserve the right to change materials and specifications without notice. Instructions packed with product. Specifications subject to change without notice. Ref. W10555563 5/3/13

  • 1
  • 2
Side by Side Built-In Refrigerator
IMPORTANT:
■
Flooring under refrigerator must be at same level as the room. Face of cabinetry
must be plumb.
■
The width of the opening (Width A), must be as specified for your model, for at
least 2" (5.08 cm) back from the face of the cabinet. If your opening does not
meet this requirement, you will need to make modifications.
PRODUCT DIMENSIONS
■
The power cord is 84" (213 cm) long.
■
The line attached to the back of the refrigerator is 5 ft. (1.5 m) long.
■
Width dimensions were measured from trim edge to trim edge.
■
The depth from the front of the top grille to the back of the refrigerator cabinet is
25
3
/
8
" (64.5 cm).
■
Height dimensions are shown with leveling legs extended
1
/
8
" (3mm) below the
rollers.
SIDE VIEW
*When leveling legs are fully extended to 1
1
/
4
" (3.2 cm) below rollers, add 1
1
/
8
"
(2.9 cm) to the height dimensions.
TOP VIEW
PRODUCT MODEL NUMBERS
Electrical:
A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded electrical
supply is required. It is recommended that a separate circuit serving only your
refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not
use an extension cord.
A grounded 3 prong electrical outlet should be placed within 4" (10.2 cm) of the right
side cabinets or end panel.
Water Supply:
A cold water supply with water pressure between 30 and 120 psi (207
and 827 kPa) is required to operate the water dispenser and ice maker. If you have
questions about your water pressure, call a licensed, qualified plumber.
IMPORTANT:
If a reverse osmosis water filtration system is connected to your cold
water supply, the water pressure coming out of the reverse osmosis system going to
the water inlet valve of the refrigerator needs to be between 30 and 120 psi (207 and
827 kPa).
The water shutoff should be located in the base cabinet on either side of the
refrigerator or some other easily accessible area. If the water shutoff valve is not in the
cabinets, the plumbing for the water line can come through the floor or the back wall.
Location:
Do not install the refrigerator near an oven, radiator, or other heat source,
or in a location where the temperature will fall below 55°F (13°C). Floor must
support the refrigerator weight, more that 600 lbs (272 kg), door panels and
contents of the refrigerator.
OPENING DIMENSIONS
To avoid tipping during use, the solid soffit must be within 1" (2.5 cm) maximum
above the refrigerator. If the solid soffit is higher than 1" (2.5 cm) or one isnot
available, then the refrigerator must be braced.
If the anti-tip boards are needed, they must be attached to the rear wall studs 80" to
90" (203 cm to 229 cm) above the floor. See “Install Anti-Tip Boards” for more
information.
NOTE:
A clearance of
1
/
2
" (1.3 cm) above the top grille must be maintained in order
for the top grille to be removed.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. W10555563
5±3±13
80" - 90"
(203-229 cm)
6"
(15.2 cm)
83
¹⁄₂
" (212.1 cm) min.
84
³⁄₄
" (215 cm) max.
to bottom of solid soffit
24"
(60.96 cm) min.
1"
(2.54 cm)
77"
(196 cm)
6"
(15.2 cm)
6"
(15.2 cm)
A
Width
(see chart following)
B
Dimension
Model
Width A
(as shown)
Width A for
Overlay Models
(as shown)
Dimension B
(as shown)
36
35
¹⁄₂
" to 35
³⁄₄
"
(90.2 cm to
90.8 cm)
35
³⁄₄
" to 36"
(90.8 cm to
91.4 cm)
4" (10.2 cm)
42
41
¹⁄₂
" to 41
³⁄₄
"
(105.4 cm to
106 cm)
41
³⁄₄
" to 42"
(106 cm to
106.7 cm)
10" (25.4 cm)
48
47
¹⁄₂
" to 47
³⁄₄
"
(120.7 cm to
121.3 cm)
47
³⁄₄
" to 48"
(121.3 cm to
121.9 cm)
16" (40.6 cm)
KSSC36FT
KSSC36QT
KSSC42FT
KSSC42QT
KSSC42QV
KSSC48FT
KSSC48QT
KSSC48QV
KSSO36FT
KSSO36QT
KSSO42FT
KSSO42QT
KSSO48FT
KSSO48QT
KSSS36FT
KSSS36QT
KSSS42FT
KSSS42QT
KSSS48FT
KSSS48QT
25
³⁄₈
"
(64.5 cm)
23
¹⁄₂
"
(59.7 cm)
84" (213.4 cm)
Power Cord
*83
³⁄₈
"
(211.8 cm)
*3
¹⁄₂
" (8.9 cm)
Model
Width A
36
35
" (88.9 cm)
42
41
" (104.1 cm)
48
47
" (119.4 cm)
25
³⁄₈
"
(64.5 cm)
A