KitchenAid KBFS22ECMS Use & Care Guide - Page 5
Warning
View all KitchenAid KBFS22ECMS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
■ Dispose of/recycle all packaging materials. When Moving Your Beverage Center: Your beverage center is heavy. When moving the appliance for cleaning and service, be sure to protect the floor. Always pull the appliance straight out when moving it. Do not wiggle or "walk" the appliance when trying to move it, as floor damage could occur. Clean Before Using After you remove all of the packaging materials, clean the inside of your beverage center before using it. See the cleaning instructions in "Beverage Center Care." Important information to know about glass shelves and covers: Do not clean glass shelves or covers with warm water when they are cold. Shelves and covers may break if exposed to sudden temperature changes or impact, such as bumping. For your protection, tempered glass is designed to shatter into many small, pebble-size pieces. This is normal. Glass shelves and covers are heavy. Use special care when removing them to avoid impact from dropping. Door Closing Door Closing Your beverage center has four leveling legs. If your beverage center seems unsteady or you want the door to close more easily, adjust the beverage center's tilt using the instructions below. WARNING WARNING Excessive Weight Hazard Use two or more people to move and install beverage center. Failure to do so can result in back or other injury. 2. Move the beverage center into its final location. 3. Turn the leveling legs to the right to lower the beverage center or turn the leveling legs to the left to raise it. It may take several turns of the leveling legs to adjust the tilt of the beverage center. NOTE: Having someone push against the top of the beverage center takes some weight off the leveling legs. This makes it easier to adjust the leveling legs. 4. Open the door and check to make sure that it closes as easily as you like. If not, tilt the beverage center slightly more to the rear by turning both front leveling screws to the right. It may take several more turns, and you should turn both leveling legs the same amount. Base Grille Remove the Base Grille 1. Open the beverage center door. 2. Using a Phillips screwdriver, remove the two screws. Push both tabs in toward the center to release the base grille from the beverage center. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. A B A A. Tabs B. Screws 3. Remove the base grille. Replace the Base Grille 1. Open the beverage center door. 2. Position the base grille so that both tabs align and the base grille snaps into place. Replace the two screws. Tighten the screws. 5