KitchenAid KBNU487VSS Use & Care Guide - Page 5
Installation Requirements - grill
View all KitchenAid KBNU487VSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. 20 lb LP Gas Models Natural Gas Models Tools Needed ■ Tape measure ■ Wrench or pliers ■ Small, flat-blade screwdriver ■ Pipe wrench ■ Flat-blade screwdriver ■ Scissors or cutting pliers ■ #2 and #3 Phillips screwdriver (to remove tiedowns) ■ Level ■ Noncorrosive leakdetection solution Parts Supplied ■ Gas pressure regulator/hose assembly set for 11" WCP LP gas (attached to manifold). ■ Rotisserie motor mounting bracket ■ Rotisserie motor ■ Rotisserie forks ■ Rotisserie spit ■ Smoker box ■ 1 single-prong plug/500 mAmp transformer assembly for the rotisserie motor ■ 1 single-prong plug/5,000 mAmp transformer assembly for the grill (power supply) ■ Convertible regulator set for 4" WCP Natural gas ■ Conversion kit for Natural gas ■ LP gas fuel tank tray ■ 1.5 V "D" size alkaline batteries ■ Vinyl grill cover Parts Needed - 20 lb LP gas models ■ 20 lb LP gas fuel tank - approximately 18" (45.7 cm) height and 12" (30.5 cm) diameter Tools Needed ■ Tape measure ■ Wrench or pliers ■ Small, flat-blade screwdriver ■ Pipe wrench ■ Flat-blade screwdriver ■ Scissors or cutting pliers ■ #2 and #3 Phillips screwdriver (to remove tiedowns) ■ Level ■ Noncorrosive leakdetection solution Parts Supplied ■ Convertible regulator set for 4" WCP Natural gas ■ 1 single-prong plug/500 mAmp transformer assembly for the rotisserie motor (on some models) ■ 1 single-prong plug/5000 mAmp transformer assembly for the grill (power supply) ■ 1.5-volt "D" size alkaline battery (on some models) ■ Rotisserie motor mounting bracket (on some models) ■ Rotisserie motor (on some models) ■ Rotisserie forks (on some models) ■ Rotisserie spit (on some models) ■ Smoker box (on some models) Parts Needed ■ Gas line shutoff valve ■ ½" male pipe thread nipple for connection to pressure regulator ■ LP gas-resistant pipe-joint compound ■ CSA design-certified outdoor flexible stainless steel appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply line as needed 5