KitchenAid KBPU182VSS Use & Care Guide - Page 16
Conversion from LP Gas to Natural Gas
UPC - 883049184746
View all KitchenAid KBPU182VSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
5. Use adjustable wrench to remove LP hose regulator from brass elbow. Use adjustable wrench to remove brass elbow. 11. Remove stem from cap, turn it over and snap stem back into the cap so the letters "LP" are at the end of the stem farthest away from the brass cap. LP A B C 12. Use adjustable wrench to reinstall cap onto regulator. Make Power™ Burner Connections D A. Manifold B. Brass elbow C. Rear of Power™ burner D. Gas pressure regulator/hose assembly 6. Apply pipe sealant to the threads of the brass connector. Use pipe thread sealant that is certified for use with LP gas. 7. Use adjustable wrench to install brass connector (supplied) to manifold fitting. NOTE: The arrow on the regulator must be pointing toward the brass connector. 8. Use pipe wrench to install the convertible regulator. Brass cap will be facing up when tight. A B Connect Local LP Gas Supply 1. Use pipe wrench to connect certified ½" (1.3 cm) gas supply pipe to inlet side of regulator from Fixed LP gas supply according to local codes requirements. Use pipe thread sealant that is certified for use with LP gas at connections where required. There must be a certified manual shutoff valve in the gas supply line near the Power™ burner for easy access. 2. Turn on the gas supply to the Power™ burner. 3. Test all connections by brushing on an approved noncorrosive leak-detection solution. Bubbles will show a leak. Correct any leaks found. Record Conversion In the last page of the Use and Care Guide, write "Converted to Local LP Gas Supply." Also record the conversion date and the technician/company that performed the conversion. Conversion from LP Gas to Natural Gas Installation of the regulator 1. Turn off the main gas supply valve. 2. Unplug Power™ burner or disconnect power. 3. Disconnect 20 lb LP gas fuel tank (if present). 4. Turn off all burner control valves. 5. Use adjustable wrench to remove LP hose regulator from brass elbow. Use adjustable wrench to remove brass elbow. A. Brass connector B. Convertible regulator A 9. To set the appliance regulator for LP gas, use adjustable wrench to remove the brass cap on the convertible regulator. B C 10. Examine the stem on the brass cap. The letters "NAT" should be showing on the end of the plastic stem farthest away from the brass cap. 16 D A. Manifold B. Brass elbow C. Rear of Power™ burner D. Gas pressure regulator/hose assembly