KitchenAid KBSD702MPS Owners Manual - Page 26
Install Odor Absorber (on some models), Complete Installation, Water System Preparation
View all KitchenAid KBSD702MPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
5. Using the 2 screws, attach the base grille assembly to the refrigerator as shown. NOTE: Drive in the right side screw first. A. Screws (2) Install Odor Absorber (on some models) On some models, your refrigerator's accessory packet includes an odor absorber, which must be installed prior to use. On some models, the odor absorber is already installed at the factory. The odor absorber reduces the buildup of odors. This helps to maintain a cleaner environment inside the refrigerator. Installing the Odor Absorber (on some models) The absorber should be installed behind the vented door, which is located (depending on your model) along either the rear or left interior wall near the top of the refrigerator compartment. Replacing the Odor Absorber The disposable odor absorber should be replaced every 6 months, when the status indicator has completely changed from white to red. To order a replacement odor absorber, see "Accessories" in the User Instructions or User Guide. � Remove the old odor absorber by squeezing in on the side tabs. � Remove the old status indicator. � Install the new odor absorber and status indicator using the instructions in the previous sections. Complete Installation 1. Turn the water supply line valve to the "Open" position. 2. Turn the refrigerator switch to the ON position. See "Power On/Off Switch" in the Use & Care Guide for instructions. Wait a few minutes. Check the water line connections for leaks. 3. Remove all boxes, parts packages and packing materials from the interior of the refrigerator. See the "Cleaning" section in the Use & Care Guide for instructions. Remove the film and cardboard from the grille and doors or door frame, depending on your model. 4. Install the shelves and bins in the refrigerator and freezer compartments. 5. The controls are preset at the factory to the midpoint setting. Make sure the compressor is operating properly and that all the lights are working. 6. Flush the water system before use. See "Water System Preparation." To get the most efficient use from your new built-in refrigerator, read the Use & Care Guide. Keep Installation Instructions and Use & Care Guide near the built-in refrigerator for easy reference. Water System Preparation Please read before using the water system. Follow the directions specific to your model. Style 1 (Dispenser Models) IMPORTANT: After connecting the refrigerator to a water source or replacing the water filter, follow the steps below to make sure that the water system is properly cleaned. This will flush air from the filter and water dispensing system, and prepare the water filter for use. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. NOTE: If your model has a base grille filter system, make sure the base grille filter is properly installed and the cap is in the horizontal position. 1. Remove the odor absorber from its packaging. 2. Snap the absorber in to place. 3. Pinch the tabs on the odor absorber to remove the absorber. 26