KitchenAid KCMS1555SSS Installation Guide - Page 3
Microwave Oven Preparation, Bottom Duct Assembly, Side Duct and Upper Duct Assembly
UPC - 883049119342
View all KitchenAid KCMS1555SSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Recommended: ■ A time-delay fuse or time-delay circuit breaker. ■ A separate circuit serving only this microwave oven. GROUNDING INSTRUCTIONS ■ For all cord connected appliances: The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded. Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven. SAVE THESE INSTRUCTIONS Microwave Oven Preparation 1. Unplug microwave oven before proceeding with installation. 2. Remove any loose items inside microwave oven. Bottom Duct Assembly 1. Fasten bottom bracket to bottom duct using two ¹⁄₂" screws. (Rear view of bottom duct) A B A. Bottom bracket B. ¹⁄₂" screws 2. Remove 2 existing screws from right side of microwave oven, and 1 existing screw from left side. 3. Install bottom duct with 2 existing screws on right side of oven. (Front view of microwave oven) A A. Existing screws Side Duct and Upper Duct Assembly 1. Connect side duct to upper duct: Insert projecting tabs of upper duct into holes of side duct. Then bend tabs upward. A B A. Tabs of upper duct B. Holes in side duct NOTE: Remove any dirt or oil on microwave oven surface before ducts are attached. 2. Peel off backing of double-sided tape. Align the duct assembly screw hole to the existing screw hole on left side of microwave oven, and attach the duct assembly to the oven. Press down firmly on ducts, then fasten with existing screw. A A. Existing screw 3