KitchenAid KDTE104DSS Use & Care Guide - Page 15

It is very easy to remove and maintain the filters. The chart below shows the recommended cleaning frequency. RECOMMENDED TIME INTERVALS TO CLEAN YOUR FILTER Number of Loads If you wash Per Week before loading If you scrape and rinse If you only scrape before loading before loading* 1-3 Once per year Once per year Twice per year 4-7 Once per year Once per year Twice per year 8-12 Once per year Twice per year Every three months 13-14 Once per year Twice per year Every three months If you do not scrape or rinse before loading Every two months Once per month Every two weeks Once per week *Manufacturer's recommendation: This practice will conserve the water and energy that you would have used to prepare your dishes. This will also save you time and effort. Very Hard Water If you have hard water (above 15 grains), clean your filter at least once per month. Building up of white residue on your dishwasher indicates hard water. For tips on removing spots and stains, see "Troubleshooting" section. Filter Removal Instructions 1. Turn the Upper Filter Assembly ¼ turn counterclockwise and lift out. 2. Grasp the Lower Filter in the circular opening, lift slightly, and pull forward to remove. 3. Clean the filters as shown below. PUSH DOWN & TURN K UNLOCK To remove Upper Filter Assembly Cleaning Instructions IMPORTANT: Do not use wire brush, scouring pad, etc., as they may damage the filters. Rinse filter under running water until most soils are removed. If you have hard-to-remove soils or calcium deposits from hard water, a soft brush may be required. N & TUR C LO Filter Reinstallation Instructions 1. Noting the previous illustrations, place the Lower Filter under the Locating Tabs in the bottom of the dishwasher so the round opening for the Upper Filter Assembly lines up with the round opening in the bottom of the tub. N K C LO PUSH DOW UNLOCK To replace Upper Filter Assembly 2. Insert the Upper Filter Assembly into the circular opening in the Lower Filter. 3. Slowly rotate the filter clockwise until it drops into place. Continue to rotate until the filter is locked into place. If the filter is not fully seated (still turns freely), continue to turn the filter clockwise until it drops and locks into place. NOTE: The Upper Filter Assembly arrow does not have to align with the arrow in the Lower Filter as long as the filter is locked. IMPORTANT: To avoid damage to dishwasher, do not operate your dishwasher without the filters properly installed. Be sure the Lower Filter is securely in place and the Upper Filter Assembly is locked into place. If the Upper Filter Assembly turns freely, it is not locked into place. Cleaning Cleaning the exterior Dishwasher Care In most cases, regular use of a soft, damp cloth or sponge and a mild detergent is all that is necessary to keep the outside of your dishwasher looking nice and clean. If your dishwasher has a stainless steel exterior, a stainless steel cleaner is recommended, such as affresh®† Stainless Steel Cleaner Part Number W10355016. †® affresh is a registered trademark of Whirlpool, U.S.A. 15