KitchenAid KDTE254ESS Installation Guide - Page 10
Option A, Waste Disposer - No Air Gap, Option B, No Waste Disposer - No Air Gap, Option C, Waste
View all KitchenAid KDTE254ESS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Option B, No Waste Disposer - No Air Gap IMPORTANT: The drain hose connection of the disposer or a waste tee must be made before the drain trap and at least 20" (50.8 cm) above the floor where the dishwasher will be installed. Helpful Tip: To reduce vibration of the hose, keep the hose away from the floor. Option A, Waste Disposer - No Air Gap 1. Fit rubber end of drain hose to waste tee and cut if needed. NOTE: Do not cut ribbed section. 2. Attach rubber end of drain hose to waste tee with a large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1¹⁄₂" to 2" (3.8 to 5 cm) screwtype clamp (not provided). Option C, Waste Disposer - With Air Gap Helpful Tip: Remove disposer knockout plug. 1. Using a hammer and screwdriver, knock plug into disposer. 2. Use needle-nose pliers to remove plug. 3. Attach drain hose to disposer inlet with large drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. 10