KitchenAid KDTM354EBS Use & Care Guide - Page 10

OPTION SELECTIONS OPTIONS CAN BE SELECTED WITH WHAT IT DOES ADDED TIME TO CYCLE TYPICAL MAX ADDED WATER GALLONS (LITERS) Sanitizes dishes and glassware in Heavy Duty Increases the main 53 accordance with NSF International NSF/ Normal wash temperature ANSI Standard 184 for Residential Dishwashers. Certified residential Wash from 105°F (41°C) ProWash™ to 140°F (60°C) and dishwashers are not intended for licensed the final rinse from food establishments. Only sanitizing cycles 140°F (60°C) to have been designed to meet the 155°F (68°C). requirements of the NSF/ANSI 184 performance standard for soil removal and for sanitization efficacy. There is no intention, either directly or indirectly, that all cycles on a NSF/ANSI 184 certified dishwasher meet the NSF/ANSI 184 performance standard for soil removal and for sanitization efficacy. 73 0 - 4.68 (0 - 18.7) The Sani Rinse indicator indicates at the end of the cycle whether the Sani Rinse option was successfully completed. If the indicator does not activate, it is probably due to the cycle being interrupted. NOTE: If option is selected, only fresh water will be used throughout the entire cycle. Dries dishes with heat. This option with the Available Activates the 52 52 0 use of rinse aid will provide the best drying with any heating element at performance. Plastic items are less likely to cycle the end of the wash deform when loaded in the top rack. Turn cycle to speed Heat Dry off for an air dry. drying times. Heat Dry defaults to ON when any cycle is selected. Runs the dishwasher at a later time or during Available Delays the start of a 240 240 0 off-peak electrical hours. Select a wash cycle with any cycle up to 4 hours. and options. Press 4 Hour Delay. Press cycle START/RESUME. Close the door firmly. NOTE: Anytime the door is opened (such as, to add a dish), the Start/Resume button must be pressed again to resume the delay countdown. Control Lock Avoids unintended use of the dishwasher between cycles, or cycle and option changes during a cycle. To turn on Lock, press and hold CONTROL LOCK for 3 seconds. The Control Lock light will stay on for a short time, indicating that it is activated, and all buttons are disabled. If you press any button while your dishwasher is locked, the light flashes 3 times. The dishwasher door can still be opened/closed while the controls are locked. NOTE: You may need to disable Sleep Mode by pressing either Start/Resume or Cancel, or by opening and closing the door before you are able to turn Control Lock off. To turn off Control Lock, press and hold CONTROL LOCK for 3 seconds. The light turns off. CONTROLS AND CYCLE STATUS Control Purpose Comments To start or resume a wash cycle If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator flashes. The cycle will not resume until the door is closed and Start/Resume is pressed. NOTE: If the Start/Resume button is located on top of door, push door firmly closed within 3 seconds of pressing Start/Resume. If the door is not closed within 3 seconds, the Start/ Resume button LED will flash, an audible tone will be heard, and the cycle will not start. To reset any cycle or options during selection. To cancel a wash cycle after it's started. Press and hold CANCEL/DRAIN to reset any control selections made. See "Canceling A Cycle After Dishwasher Is Started" and "Changing A Cycle After Dishwasher Is Started" sections in the full User Guide. 10