KitchenAid KEHU309SSS Installation Guide - Page 6

4-Wire Cable from Home Power Supply IMPORTANT: Use the 4-wire cable from home power supply in the U.S. where local codes do not allow grounding through neutral, New Branch circuit installations (1996 NEC), mobile homes and recreational vehicles, new construction and in Canada. A B E F G C H D I A. Cable from home power supply B. Black wires C. Red wires D. 4-wire flexible conduit from oven E. Junction box F. White wires G. UL listed wire connectors H. Green (or bare) ground wires I. UL listed or CSA approved conduit connector 1. Connect the 2 black wires (B) together using a UL listed wire connector. 2. Connect the 2 red wires (C) together using a UL listed wire connector. 3. Untwist white wire from green (or bare) ground wire coming from the oven. 4. Connect the 2 white wires (F) together using a UL listed wire connector. 5. Connect the green (or bare) ground wire (H) from the oven cable to the green (or bare) ground wire (in the junction box) using a UL listed wire connector. 6. Install junction box cover. 3-Wire Cable from Home Power Supply - U.S. Only IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection. A B C G H D E I F A. Cable from home power supply B. Junction box C. Black wires D. White wires E. Green (or bare) ground wire (from oven) F. 4-wire flexible conduit from oven G. Red wires H. UL listed wire connectors I. UL listed or CSA approved conduit connector 1. Connect the 2 black wires (C) together using a UL listed wire connector. 2. Connect the 2 white wires (D) and the green (or bare) ground wire (of the oven cable) using a UL listed wire connector. 3. Connect the 2 red wires (G) together using a UL listed wire connector. 4. Install junction box cover. Install Water Filtration System Install Water Filter 1. Install the water filter near the cold water supply pipe under the kitchen sink to filter the cold water. IMPORTANT: Be sure to allow a minimum clearance of 1½" (3.8 cm) under the filter system for removing the filter cartridge. Typical Installation Configuration NOTE: For unique installations contact a licensed plumber. Water supply line to oven Cold water supply Hot Cold Filter Assembly Water supply line to cold water supply 2. Attach the supplied water filter mounting ring and screw at the recommended location. 3. Attach filter to the mounting ring. Mounting ring and screw 1½" (3.8 cm) clearance Connect to Home Water Supply 1. Make connection to the cold water supply line. ■ A leak-tight connection to the ¼" copper tubing must be provided. ■ Check local codes for type of connection required. ■ Copper water supply tubing must be cut with a copper tubing cutter so the ends are concentric and without burrs. NOTE: It is recommended that the cold water line be soft water. 6