KitchenAid KFCS22EVMS Use & Care Guide - Page 11
Troubleshooting - problems
UPC - 883049132778
View all KitchenAid KFCS22EVMS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Changing the Light Bulb NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to replace the bulb with an appliance bulb of the same size, shape, and wattage (no greater than 40 watts). Changing the Refrigerator Light Bulb 3. Replace burned-out bulb(s) with appliance bulb(s) no greater than 40 watts. 4. Replace the light shield by inserting the tabs on the shield into the liner holes on each side of light assembly. Slide the shield toward the front until it locks into place. 1. Unplug the refrigerator or disconnect power. NOTE: To avoid damaging the light shield, do not force the shield beyond the locking point. 2. Slide the light shield toward the back of the compartment to release it from the light assembly. 5. Plug in refrigerator or reconnect power. Changing the Freezer Light Bulb 1. Unplug refrigerator or disconnect power. 2. Remove the burned-out bulb and replace it with an appliance bulb no greater than 40 watts. 3. Plug in refrigerator or reconnect power. TROUBLESHOOTING First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call. In the U.S.A., www.kitchenaid.com In Canada, www.kitchenaid.ca Refrigerator Operation The refrigerator will not operate WARNING The motor seems to run too much Your new refrigerator may run longer than your old one due to its high-efficiency compressor and fans. The unit may run even longer if the room is warm, a large food load is added, doors are opened often, or if the doors have been left open. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. ■ Power cord unplugged? Plug into a grounded 3 prong outlet. ■ Is outlet working? Plug in a lamp to see if the outlet is working. ■ Household fuse blown or circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. ■ Are controls on? Make sure the refrigerator controls are on. See "Using the Controls." ■ New installation? Allow 24 hours following installation for the refrigerator to cool completely. NOTE: Adjusting the temperature controls to coldest setting will not cool either compartment more quickly. The refrigerator seems noisy Refrigerator noise has been reduced over the years. Due to this reduction, you may hear intermittent noises from your new refrigerator that you did not notice from your old model. Below are listed some normal sounds with explanations. ■ Buzzing - heard when the water valve opens to fill the ice maker ■ Pulsating - fans/compressor adjusting to optimize performance ■ Hissing/Rattling - flow of refrigerant, movement of water lines, or from items placed on top of the refrigerator ■ Sizzling/Gurgling - water dripping on the heater during defrost cycle ■ Popping - contraction/expansion of inside walls, especially during initial cool-down ■ Water running - may be heard when water melts during the defrost cycle and runs into the drain pan ■ Creaking/Cracking - occurs as ice is being ejected from the ice maker mold. 11