KitchenAid KFGC558JYP Installation Instructions - Page 9

INSTALLATION INSTRUCTIONS WARNING Unpack the Range 2. For 48" (121.9 cm) models only, rotate center support counterclockwise off the pallet until it stops. Excessive Weight Hazard Use two or more people to move and install range. Failure to do so can result in back or other injury. Remove shipping materials, tape, and film from range. Keep shipping pallet under range. Remove oven racks, and parts package from inside oven. Remove grates from top of oven. Remove Kick Plate 1. Your range will have the kick plate packaged on top of the unit. a. Remove kick plate from top of range and grate pack. In packaging A A. Kick plate Packaging removed NOTE: This support is used only for shipping and is not needed for installation. 3. Lay a piece of cardboard from packaging on the floor behind range. Using two or more people, firmly grasp each side of range. Lift range up about 3" (8.0 cm) and move it back until range is off shipping pallet. Set range on cardboard to avoid damaging floor. Remove Door Door Removal ■ Do not remove the side door spacers until the range is ready to install. Removing the door spacers could allow the door to shift, damaging the door latch. ■ Do not lift or move the range by the door handle(s) or control panel. ■ Prior to installing the range, you will need to remove the oven door(s). Prepare a surface where you will place the door(s). This surface should be flat and covered with a soft blanket, or use the corner posts from the packaging material. A A A. Kick plate b. Lay kick plate to the side to avoid scratching. A. Oven door hinge in the locked position B B. Oven door hinge in the unlocked position 9