KitchenAid KGCU467VSS Dimension Guide - Page 1

® Commercial Style Gas Cooktop PRODUCT MODEL NUMBERS KGCU407V KGCU462V KGCU463V KGCU467V KGCU482V KGCU483V KGCU484V Type of Gas Natural Gas: This cooktop is design-certified by CSA International for use with Natural gas or, after proper conversion, for use with LP gas. This cooktop is factory-set for use with Natural gas. To convert to LP gas, see the Gas Conversion instructions provided in the package containing literature. The model/ serial rating plate located on the left underside of the cooktop burner base has information on the types of gas that can be used. If the types of gas listed do not include the type of gas available, check with the local gas supplier. LP Gas conversion: Conversion must be done by a qualified service technician. No attempt shall be made to convert the cooktop from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. To convert to LP gas, use the LP gas conversion kit provided with the cooktop and see the "Gas Conversions" section. Electrical: A 120-volt, 60-Hz, AC-only, 15-amp, fused electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this cooktop be provided. LOCATION REQUIREMENTS IMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air. It is the installer's responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located on the underside of the cooktop burner base. It is recommended that a 600 CFM or larger vent hood be installed above the cooktop. It is not recommended that a microwave hood combination be mounted above the cooktop. The cooktop should be installed in a location away from strong draft areas, such as windows, doors and strong heating vents or fans. All openings in the wall or floor where cooktop is to be installed must be sealed. Cabinet opening dimensions that are shown must be used. Given dimensions are minimum clearances. IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. PRODUCT DIMENSIONS C D E B A A. 30" (76.2 cm) cooktop: 29⁵⁄₈" (75.1 cm) 36" (90.4 cm) cooktop: 35⁵⁄₈" (90.4 cm) 48" (121.9 cm) cooktop: 47⁵⁄₈" (120.8 cm) B. 36" (91.4 cm) long 3 prong grounding-type power supply cord C. Model/serial rating plate (located on the underside of the cooktop burner base) D. Island trim or optional backguard E. 27¾" (70.5 cm) A B C G E Side View of Cooktop F D A. 27¾" (70.5 cm) B. 1¼" (3.2 cm) C. 7 18.8 cm) D. Gas inlet is located 1⁷⁄₈" (4.8 cm) from the back of the cooktop burner base and 4⁷⁄₈" (12.4 cm) in from left-hand side of the cooktop burner base. E. 22" (55.9 cm) F. 3⁵⁄₈" (9.2 cm) G. 1" (2.6 cm) Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation our products, we reserve the right to change materials and specifications without notice. Instructions packed with product. Specifications subject to change without notice. Page 1 of 2 Ref. W10271686D 08/26/09