KitchenAid KGSS907S Installation Instructions - Page 14
Check Operation of Oven Bake Burner, Adjust Oven Bake Flame if needed, Check Operation of Oven Broil - door locked
UPC - 883049027548
View all KitchenAid KGSS907S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Check Operation of Oven Bake Burner 1. Remove the oven rack. Remove the bake burner cover and place it on a covered surface. 2. Push the BAKE pad. Default temperature appears in the temperature display. 3. Press the START pad. "Preheating" and "Lo" (or actual temperature) will appear in the temperature display. The oven bake burner should light within 8 seconds, under certain conditions it may take the burner up to 50 to 60 seconds to light. Electronic igniters are used to light the bake and broil burners. A B C A. Oven bake burner cover B. Flame spreader C. Oven bake burner Adjust Oven Bake Flame (if needed) 1. Remove access cover plate (2 screws) located on the upper wall, inside the storage or warming drawer compartment. 2. Check the oven bake burner for proper flame. This flame should have a ½" (1.3 cm) long inner cone of bluish-green, with an outer mantle of dark blue, and should be clean and soft in character. No yellow tips, blowing or lifting of flame should occur. 3. If the oven bake flame needs to be adjusted, locate the air shutter near the center rear of the range. Use a flat-blade screwdriver to loosen the locking screw. Rotate the air shutter until the proper flame appears. Tighten locking screw. Check Operation of Oven Broil Burner 1. Close the oven door. 2. Press the BROIL pad. "FULL BROIL" and broil temperature will appear in the temperature display. 3. Press the START pad. "ON" indicator will light. The oven burner should light within 8 seconds, under certain conditions it may take the burner up to 50 to 60 seconds to light. On some models, an electric halo element also turns on. A B A. Gas burner B. Electric halo element NOTE: Oven door must be shut for broil burner to operate. Adjust Oven Broil Burner Flame (if needed) Look through oven window to check broil burner for proper flame. This flame should have a ½" (1.3 cm) long inner cone of bluish-green, with an outer mantle of dark blue, and should be clean and soft in character. No yellow tips, blowing or lifting of flame should occur. B A A. Air shutter B. Locking screw 4. Push CANCEL/OFF pad. 5. Reinstall oven bake burner access plate. A B A. Locking screw B. Air shutter If flame needs to be adjusted: 1. Use a flat-blade screwdriver to loosen the locking screw on the air shutter located at the rear of the broil burner. 2. Adjust the air shutter as need. 3. Tighten lock screw. 14