KitchenAid KGSS907SSS Use & Care Guide - Page 25

Troubleshooting - problems

Page 25 highlights

TROUBLESHOOTING Try the solutions suggested here first in order to avoid the cost of an unnecessary service call. Nothing will operate Gas range noises during Bake and Broil operations WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Noises that may be heard during the Bake and Broil operations: Whooshing, Poof, Clicking, Snaps, Pop These sounds are normal operational noises that can be heard each time the Bake or Broil burners ignite during the cycle. ■ A pop can be heard when the gas valve is opening or cycling on and will make a single pop when it snaps open from the solenoid. It sounds similar to a suction cup being pulled off of a piece of glass. ■ The igniters will click several times until the flame is detected. These are short clicking sounds like tapping a nail onto a piece of glass. ■ A whooshing or poof sound is heard when the Bake or Broil burner ignites. ■ On some models, a clicking sound can be heard when the convection fan relay cycles on and off. Burner sparks but does not light ■ Is the power supply cord unplugged? Plug into a grounded outlet. ■ Has a household fuse blown or has a circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. ■ Is the range properly connected to the gas supply? Contact a trained repair specialist or see Installation Instructions. Surface burners will not operate ■ Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines. ■ Is the control knob set correctly? Push in knob before turning to a setting. ■ Are the burner ports clogged? See "Surface Burners" section. ■ Is there continuous sparking, but the burner does not light? Discontinue use of the surface burner and contact a service technician. Excessive heat around cookware on cooktop ■ Is the cookware the proper size? Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than ½" (1.3 cm) outside the cooking area. Cooktop cooking results not what expected ■ Is the proper cookware being used? See "Cookware" section. ■ Is the control knob set to the proper heat level? See "Cooktop Controls" section. ■ Is the range level? Level the range. See the Installation Instructions. Surface burner flames are uneven, yellow and/or noisy ■ Are the burner ports clogged? See "Surface Burners" section. ■ On models with caps, are the burner caps positioned properly? See "Surface Burners" section. ■ Is propane gas being used? The range may have been converted improperly. Contact a trained repair specialist. Surface burner makes popping noises ■ Is the burner wet? Let it dry. Oven will not operate ■ Is this the first time the oven has been used? Turn any one of the surface burner knobs on to release air from the gas lines. ■ Is the electronic oven control set correctly? See "Electronic Oven Control" section. ■ Has a delay start been set? See "Timed Cooking" section. ■ On some models, is the Control Lock set? See "Control Lock" section. ■ On some models, is the Sabbath Mode set? See "Sabbath Mode" Section. 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56

25
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
Is the power supply cord unplugged?
Plug into a grounded outlet.
Has a household fuse blown or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Is the range properly connected to the gas supply?
Contact a trained repair specialist or see Installation
Instructions.
Surface burners will not operate
Is this the first time the surface burners have been used?
Turn on any one of the surface burner knobs to release air
from the gas lines.
Is the control knob set correctly?
Push in knob before turning to a setting.
Are the burner ports clogged?
See “Surface Burners” section.
Surface burner flames are uneven, yellow and/or noisy
Are the burner ports clogged?
See “Surface Burners” section.
On models with caps, are the burner caps positioned
properly?
See “Surface Burners” section.
Is propane gas being used?
The range may have been converted improperly. Contact a
trained repair specialist.
Surface burner makes popping noises
Is the burner wet?
Let it dry.
Gas range noises during Bake and Broil operations
Noises that may be heard during the Bake and Broil operations:
Whooshing, Poof, Clicking, Snaps, Pop
These sounds are normal operational noises that can be heard
each time the Bake or Broil burners ignite during the cycle.
A pop can be heard when the gas valve is opening or cycling
on and will make a single pop when it snaps open from the
solenoid. It sounds similar to a suction cup being pulled off of
a piece of glass.
The igniters will click several times until the flame is detected.
These are short clicking sounds like tapping a nail onto a
piece of glass.
A whooshing or poof sound is heard when the Bake or Broil
burner ignites.
On some models, a clicking sound can be heard when the
convection fan relay cycles on and off.
Burner sparks but does not light
Is there continuous sparking, but the burner does not
light?
Discontinue use of the surface burner and contact a service
technician.
Excessive heat around cookware on cooktop
Is the cookware the proper size?
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ½" (1.3 cm) outside the cooking area.
Cooktop cooking results not what expected
Is the proper cookware being used?
See “Cookware” section.
Is the control knob set to the proper heat level?
See “Cooktop Controls” section.
Is the range level?
Level the range. See the Installation Instructions.
Oven will not operate
Is this the first time the oven has been used?
Turn any one of the surface burner knobs on to release air
from the gas lines.
Is the electronic oven control set correctly?
See “Electronic Oven Control” section.
Has a delay start been set?
See “Timed Cooking” section.
On some models, is the Control Lock set?
See “Control Lock” section.
On some models, is the Sabbath Mode set?
See “Sabbath Mode” Section.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING