KitchenAid KM25G0XWH Use & Care Guide - Page 9
Assembling Your Mixer
UPC - 050946924816
View all KitchenAid KM25G0XWH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Assembling Your Mixer To Attach Bowl 1. Turn speed control to OFF. 2. Unplug Stand Mixer or disconnect power. 3. Place bowl lift handle in down position. 4. Fit bowl supports over locating pins. 5. Press down on back of bowl until bowl pin snaps into spring latch. 6. Raise bowl before mixing. 7. Plug into a grounded 3 prong outlet. To Remove Bowl 1. Turn speed control to OFF. 2. Unplug Stand Mixer or disconnect power. 3. Place bowl lift handle in down position 4. Remove flat beater, wire whip, or dough hook. 5. Grasp bowl handle and lift straight up and off locating pins. To Raise Bowl To Attach Flat Beater, Wire Whip, or Dough Hook 1. Turn speed control to OFF. 2. Unplug Stand Mixer or disconnect power. 3. Slip flat beater on beater shaft and press PIN upward as far as possible. 4. Turn beater to right, hooking beater over the pin on shaft. 5. Plug into a grounded 3 prong outlet. To Remove Flat Beater, Wire Whip, Or Dough Hook 1. Turn speed control to OFF. 2. Unplug Stand Mixer or disconnect power. 3. Press beater upward as far as possible and turn left. 4. Pull beater from beater shaft. 5. Plug into a grounded 3 prong outlet. Commercial mixer SPEED Control and Lever Guard OFREFSE/T0STIR2 4 6 8 10 RAISE 1. Rotate handle to straight-up position. 2. Bowl must always be in raised, locked position when mixing. To Lower Bowl 1. Rotate handle back and down. WARNING Injury Hazard Unplug mixer before touching beaters. Failure to do so can result in broken bones, cuts or bruises. The Soft Start™ feature minimizes splash-out by starting the mixer slowly before increasing to the selected speed. To further reduce the potential for splash-out, always begin mixing using the STIR speed, then gradually move to higher speeds as needed. See page 9 for the Speed Control Guide. Auto-Reset Motor Protection If the Stand Mixer stops due to overload, slide the speed control lever to OFF. After a few minutes, the stand mixer will automatically reset. Slide the Speed Control Lever to the desired speed and continue mixing. If the unit does not restart, see "Troubleshooting Problems" on page 5. 7