KitchenAid KMBS104ESS Installation Guide - Page 4
Installation Instructions
View all KitchenAid KMBS104ESS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
■ A UL listed or CSA approved conduit connector must be provided. ■ If the house has aluminum wiring follow the procedure below: 1. Connect a section of solid copper wire to the pigtail leads. 2. Connect the aluminum wiring to the added section of copper wire using special connectors and/or tools designed and UL listed for joining copper to aluminum. Follow the electrical connector manufacturer's recommended procedure. Aluminum/copper connection must conform with local codes and industry accepted wiring practices. For power requirements, refer to the following table. Voltage Microwave With Convection Oven 120/240 VAC 19.9 A/3250 W 120/208 VAC 19.9 A/3250 W INSTALLATION INSTRUCTIONS Spacer Kit Installation NOTES: ■ The microwave oven spacer kit allows the microwave oven to be installed in an 17 to 17⁷⁄₈" (44.1 cm to 45.3 cm) maximum cutout height. ■ If your cabinet cutout height is more than 17 44.1 cm), you must install the spacer kit. Proceed to "Assemble Spacer Kit." ■ If your cabinet cutout height is less than 17 44.1 cm), you do not have to install the spacer kit. Proceed to "Prepare Built-In Microwave Oven." 3. Attach the assembled spacer kit to the cabinet using four ¾" flat-head screws. Do not overtighten screws. A B Assemble Spacer Kit 1. Attach the bottom vent to spacer bars using four ³⁄₈" hexhead washer screws. NOTE: Spacer bar flanges should be facing out. DB C D A. ¾" pan-head screws B. Spacer kit assembly Prepare Built-In Microwave Oven 1. Locate existing wiring to avoid drilling into or severing wiring during installation. WARNING Excessive Weight Hazard Use two or more people to move and install A microwave oven. Failure to do so can result in back or other injury. A. Bottom vent B. Spacer bar flange C. Spacer bars D. ³⁄₈" hex-head washer screws Install Spacer Kit 1. Center assembled microwave oven spacer kit against lower front edge of the cabinet cutout. 2. Using an ¹⁄₈" (0.32 cm) drill bit, drill through the mounting holes in the spacer bars to create pilot holes. 2. To avoid floor damage, set the microwave oven onto cardboard prior to installation. Do not use handle or any portion of the front frame for lifting. 3. Remove the shipping materials and tape from the microwave oven. 4. Remove and set aside racks and other items from inside the microwave oven. 5. Remove the hardware package from inside the bag containing literature. 6. Move the microwave oven and cardboard close to the microwave oven's final location. 4