KitchenAid KORU06RSSS Use & Care Guide - Page 6
Warning
UPC - 883049044101
View all KitchenAid KORU06RSSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Door Closing NOTE: You can install either the leveling legs or the casters on your refrigerator. Shims can be placed under the casters to level a refrigerator that has casters installed. Door Closing Your refrigerator has four leveling legs. If your refrigerator seems unsteady or you want the door to close more easily, adjust the refrigerator tilt using the instructions below: WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. 2. Move the refrigerator into its final location. 3. Turn the leveling leg to the right to lower that side of the refrigerator or turn the leveling leg to the left to raise that side. It may take several turns of the leveling leg to adjust the tilt of the refrigerator. NOTE: Having someone push against the top of the refrigerator takes some weight off the leveling legs. This makes it easier to adjust the screws. Caster Installation (optional) Casters are an optional accessory. To order, call 1-800-442-9991 or contact your authorized KitchenAid dealer. In Canada, call, 1-800-807-6777. W IMPORTANT: s Always lay the refrigerator with hinge facing upward during the caster installation. If you lay the refrigerator on its back, you can damage the refrigerator. s Do not place refrigerator on its top. It may damage the compressor. s Allow the refrigerator to sit upright for 4 hours before plugging into an electrical outlet. 1. Unpack the casters with hardware from the small box. 2. Verify contents. s Swivel Casters with Brakes (2) s 1 Wrench s Swivel Casters (2) 3. Unplug refrigerator or disconnect power. 4. Remove food and any adjustable shelves from refrigerator. 5. Lay a piece of cardboard or other protective material on the floor. This will protect the refrigerator from scratches. 6. Using two or more people, place the refrigerator on its side with the hinge facing upward on top of the cardboard or protective material. Be sure the door hinge is facing upward. IMPORTANT: It is important that the door hinge face upward during the entire caster installation. 7. Attach both locking casters to the refrigerator front. Using the 1 wrench, tighten the locking casters. 4. Open the door again and check to make sure that it closes as easily as you like. If not, tilt the refrigerator slightly more to the rear by turning both leveling screws to the right. It may take several more turns, and you should turn both leveling screws the same amount. 6