KitchenAid KRFF300EWH Instruction Sheet - Page 1
KitchenAid KRFF300EWH Manual
View all KitchenAid KRFF300EWH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HANDLE INSTALLATION AND REMOVAL Parts Included: Freezer drawer handle (1) Tools Needed: C\cx" Hex-key wrench Install Drawer Handle 1. With the freezer drawer closed, place the handle on the shoulder screws with the setscrews facing down toward the floor. 4. Using a left to right motion tighten the setscrew a quarter-turn at a time. Repeat until the screw feels tight. 5. Repeat steps 3 and 4 to fasten the right-hand setscrew to the shoulder screw. IMPORTANT: When the screws feel tight, tighten them an additional quarter-turn. The handle is not properly installed without this extra tightening. 6. Save the hex key and all instructions. Remove the Handles A 1. While holding the handle, insert the short end of the hex key into a setscrew hole and slightly rotate the hex key until it is engaged in the setscrew. 2. Using a right to left motion loosen the setscrew a quarter-turn at a time. 3. Repeat steps 1 and 2 for the other setscrew. Slowly pull the handle away from the door or drawer. 4. If necessary, use a Phillips screwdriver to remove the shoulder B screws from the door. A. Shoulder screw B. Setscrews inside the handle 2. Firmly push the handle toward the drawer until the handle base is flush against the drawer. 3. Insert the short end of the hex key into the left-hand hole and slightly rotate the hex key until it is engaged in the setscrew. W10783605A