KitchenAid KRSC503EBS Use & Care Guide - Page 8
Remove and Replace Handle Medallions (optional), Adjust the Doors, Refrigerator USE - model
View all KitchenAid KRSC503EBS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Remove and Replace Handle Medallions (optional) The handles for your model have red medallions on the ends. Replacement medallions are available for purchase. See "Accessories" to order. 1. Using a ¹⁄₈" hex key, remove the medallion from the end of the handle. 2. Replace medallion. 3. Using the fastener removed in Step 1, attach the medallion to the handle. A ■ To lower, turn the leveling screw counterclockwise. ¹⁄₄" A B A. Leveling screw B. Front roller 3. Open the door again to make sure that it closes as easily as you like. If not, tilt the refrigerator slightly more to the rear by turning both leveling screws clockwise. It may take several more turns, and you should turn both screws the same amount. 4. Replace the base grille. REFRIGERATOR USE A. Handle medallion Adjust the Doors IMPORTANT: ■ Your refrigerator has two adjustable, front leveling screws - one on each side of the refrigerator base. If your refrigerator seems unsteady or you want the door to close easier, use the instructions below. ■ Before moving the refrigerator, raise the leveling screws so the front rollers are touching the floor. 1. Remove the two screws fastening the base grille to the cabinet, and set the screws aside. Grasp the grille and pull it toward you. Opening and Closing Doors There are two refrigerator compartment doors. The doors can be opened and closed either separately or together. There is a vertically-hinged seal on the left refrigerator door. ■ When the left-hand refrigerator door is opened, the hinged seal automatically folds inward so that it is out of the way. ■ When both doors are closed, the hinged seal automatically forms a seal between the two doors. A A. Hinged seal 2. Raise or lower the cabinet. Using a ¹⁄₄" hex driver, turn the leveling screw on each side to raise or lower that side of the refrigerator. NOTE: Having someone push against the top of the refrigerator takes some weight off the leveling screws. This makes it easier to turn the screws. It may take several turns of the leveling screw to adjust the tilt of the refrigerator. ■ To raise, turn the leveling screw clockwise. Wine Rack (on some models) Under one shelf, there are brackets installed to the supports (one bracket on each support). The wine rack rests in these brackets. To remove and replace the wine rack: 1. Remove the wine rack by lifting it up off the brackets. Press the right-hand side of the rack inward until it is free of its bracket. Lower the right-hand side slightly and disengage the left-hand side from its bracket. 8