KitchenAid KSM500PSWH Use & Care Guide - Page 11
Assembling Your Tilt-Head Mixer
View all KitchenAid KSM500PSWH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Assembling Your Tilt-Head Mixer Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 3. Tilt motor head back. 4. Slip beater onto beater shaft and press upward as far as possible. 5. Turn beater to right, hooking beater over pin of shaft. 6. Plug into a grounded 3 prong outlet. To Remove Flat Beater, Wire Whip Or Dough Hook 1. Turn speed control to OFF. 2. Unplug stand mixer. 3. Tilt motor head back. PIN 4. Press beater upward as far as possible. 5. Pull beater from beater shaft. Lock Unlock To Lock Motor Head 1. Make sure motor head is completely down. 2. Place locking lever in LOCK position. 3. Before mixing, test lock by OFF ON attempting to raise head. To Unlock Motor Head To Attach Bowl 1. Turn speed control to OFF. 2. Unplug stand mixer. 3. Tilt motor head back. 4. Place bowl on bowl clamping plate. 5. Turn bowl gently in clockwise direction. 6. Plug into a grounded 3 prong outlet. To Remove Bowl 1. Turn speed control to OFF. 2. Unplug stand mixer. 3. Tilt motor head back. 4. Turn bowl in counterclockwise direction. To Attach Flat Beater, Wire Whip, Or Dough Hook 1. Place lever in UNLOCK position. NOTE: Motor head should always be kept in LOCK position when using stand mixer. Solid State Speed Control Off Stir 2 4 6 8 10 To Operate Speed Control Plug into a grounded 3 prong outlet. Speed control lever should always be set on lowest speed for starting, then gradually moved to desired higher speed to avoid splashing ingredients out of bowl. See the "Speed Control Guide" section. 1. Turn speed control to OFF. 2. Unplug stand mixer. 11