KitchenAid KSSS48QTB Use and Care Manual - Page 18
Performance Data Sheets
UPC - 883049038445
View all KitchenAid KSSS48QTB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
PERFORMANCE DATA SHEETS Base Grille Water Filtration System Model T2WG2L/T2RFWG2 Capacity 200 Gallons (757 Liters) Model T2WG2/T2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class II*; and against NSF/ANSI Standard 53 for the reduction of Mercury, Benzene, Toxaphene, O-dichlorobenzene, and Carbofuran. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53. Substance Reduction Aesthetic Effects Chlorine Taste/Odor Particulate Class II* Contaminant Reduction Lead: @ pH 6.5*** Lead: @ pH 8.5*** Mercury: @ pH 6.5 Mercury: @ pH 8.5 Benzene O-Dichlorobenzene Toxaphene Carbofuran NSF Reduction Requirements 50% reduction 85% reduction NSF Reduction Requirements 0.010 mg/L 0.010 mg/L 0.002 mg/L 0.002 mg/L 0.005 mg/L 0.6 mg/L 0.003 mg/L 0.04 mg/L Average Influent Influent Challenge Concentration Maximum Effluent 2.0182 mg/L 2.0 mg/L ± 10% 0.06 mg/L 1333333 #/mL At least 10,000 particles/mL 6600 #/mL** Average Influent Influent Challenge Concentration Maximum Effluent 0.1533 mg/L 0.15 mg/L ± 10% 0.1400 mg/L 0.15 mg/L ± 10% 0.0005 mg/L 0.0007 mg/L 0.0058 mg/L 0.006 mg/L ± 10% 0.0059 mg/L 0.006 mg/L ± 10% 0.0002 mg/L 0.0005 mg/L 0.0154 mg/L 0.015 mg/L ± 10% 0.0012 mg/L 1.7571 mg/L 1.8 mg/L ± 10% 0.0250 mg/L 0.015 mg/L 0.015 mg/L ± 10% 0.001 mg/L 0.0819 mg/L 0.08 mg/L ± 10% 0.0400 mg/L Average Effluent 0.0536 mg/L 2325 #/mL Average Effluent 0.0005 mg/L 0.0006 mg/L 0.0002 mg/L 0.0003 mg/L 0.0006 mg/L 0.0066 mg/L 0.001 mg/L 0.0213 mg/L Minimum % Reduction 97.03 99.51 Minimum % Reduction 99.67 99.50 96.54 91.57 92.22 98.58 93.33 51.13 Average % Reduction 97.34 99.83 Average % Reduction 99.67 99.57 96.54 94.92 96.34 99.63 93.33 74.00 Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.85 gpm (3.2 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters). ■ It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. ■ These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary. ■ Use replacement filter T2RFWG2, part #4396841. 2010 suggested retail price of $39.99 U.S.A./$54.95 Canada. Prices are subject to change without notice. Model T2WG2L: Style 1 - When the filter indicator reads 10%, order a new filter. When the indicator reads 0%, it is recommended that you replace the filter. Style 2 - When the filter indicator changes from green to yellow, order a new filter. When the indicator changes from yellow to red, it is recommended that you replace the filter. ■ The product is for cold water use only. ■ Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. ■ Refer to the "Warranty" section for the Manufacturer's name, address and telephone number. ■ Refer to the "Warranty" section for the Manufacturer's limited warranty. Style 3 - When the water filter status display changes from "GOOD" to "ORDER," order a new filter. When the filter indicator reads "REPLACE," it is recommended that you replace the filter. Style 4 - Press FILTER to check the status of your water filter. If the filter indicator light is yellow, order a new filter. If the filter indicator light is red, it is recommended that you replace the filter. Application Guidelines/Water Supply Parameters Water Supply Water Pressure Water Temperature Service Flow Rate City or Well 30 - 120 psi (207 - 827 kPa) 33° - 100°F (0.6° - 37.8°C) 0.85 gpm (3.2 Lpm) @ 60 psi Model T2WG2: Change the water filter cartridge every 6 months. If the water flow to the water dispenser or ice maker decreases noticeably before 6 months have passed, replace the water filter cartridge more often. *Class II particle size: 1 um to