KitchenAid KUBR314KSS Owners Manual - Page 4
Product Dimensions
View all KitchenAid KUBR314KSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Opening and utility location dimensions Opening width - A Opening depth - B Opening height - C Dimension - D Dimension - E Dimension - F Dimension - G Dimension - H Dimension - I 24" (60.96 cm) min. 24" (60.96 cm) min. 341/2" (87.6 cm) min. 35" (88.9 cm) max. 121/16" (30.64 cm) 213/4" (55.16 cm) 13/4" (4.44 cm) 3" (7.55 cm) 41/2" (11.37 cm) 91/4" (23.47 cm) For flush installation, the power outlet can be installed in adjacent cabinetry with a cutout on the power cord side for routing of the power cord. The power outlet can also be recessed on the back wall behind the unit as per recommended receptacle locations in the above illustration. Product Dimensions Overall product Width (up to hinge cover) 237/8" (60.72 cm) Height (up to hinge cover) 343/8" (87.32 cm) Panel ready models depth (with 3/4" panel and no handle) 2313/16" (60.5 cm) Raw Door Height 305/8" (77.75 cm) Depth (no handle) 235/8" (60.01 cm) NOTE: The power cord is 60" (152.4 cm) long. 237/8" (60.72 cm) Depth (no handle) Custom Overlay Panel NOTE: For standard stainless steel or glass door models, skip these instructions and go to "Electrical Requirements" section. If you plan to install a custom overlay panel, you will need to create the panel yourself or consult a qualified cabinet maker or carpenter. Refer dimension drawings for panel specifications. IMPORTANT: The thickness of the overlay panel must be 3/4" (19 mm). Custom solid door overlay panel must not weigh more than 20 lb (9.07 kg). Custom glass door overlay panel must not weigh more than 10 lb (4.54 kg). Overlay panels weighing more than recommended may cause damage to your appliance. Solid door overlay panel - Preparation: Create the custom overlay panel using the dimensions shown in the illustration "Solid door overlay panel and hinge routing dimensions". Route shaded areas to a 1/2" (12 mm) depth as shown. IMPORTANT: The following graphic shows a custom panel for a door with the hinges installed on the right-hand side. If your beverage center has the hinges installed on the lefthand side, rotate the custom frame 180° so the hinge markings will be on the left. 1/8" (3 mm) 1/4" (7 mm) 415/16" (125 mm) 2" (53 mm) 1/2" (12 mm) 233/4" (60.3 cm) 343/8" (87.32 cm) 4 305/8" (77.5 cm) 305/8" (77.75 cm) Solid door overlay panel and hinge routing dimensions