KitchenAid KUDC03IVBS Installation Instructions - Page 15
Install Custom Panel, Option 1 - model
UPC - 883049175102
View all KitchenAid KUDC03IVBS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Custom panel dimensions - Dishwashers with control panel on the front (65.8 cm) (19.1 mm) 1 Custom panel installation - Dishwashers with control panel on the top 23¹⁄₂" (59.7 cm) *30 76.7 cm) (3.2 mm) * This dimension is for 4" (10.2 cm) toe kick. If the installation needs a higher toe kick, adjust the height of the wood panel accordingly. Not recommended for toe kicks greater than 6" (15.2 cm). Follow directions in Option 2 of "Install custom panel" section. Install Custom Panel - Option 1 (Models KUDS40FVPA, KUDS50FVPA, KUDE60FVPA, and KUDE70FVPA) NOTE: The handle for the custom panel is not included. IMPORTANT: If the handle is attached from the back of the custom panel, the screw holes should be countersunk for the screws heads to be flush with the panel. If the handle is attached to the front of the custom panel, the screw lengths cannot exceed the panel thickness. For more information on KitchenAid custom handle selection, refer to the KitchenAid Catalog, visit www.kitchenaid.com, or call 1-800-422-1230. NOTE: A customer-supplied full-front panel must weigh no more than 16 lbs (7.3 kg) and must be made to specific dimensions. It is recommended that a cabinetmaker cut the custom panel because of the precise dimensions needed. NOTE: All mounting hardware supplied is for a ³⁄₄" (19.1 mm) thick wood panel. If a thinner wood panel, or materials other than wood are used, it is the consumer's responsibility to obtain the proper length screws and adjust the pilot holes accordingly. IMPORTANT: Use a moisture-resistant sealer on both sides and all edges of the panel to avoid damage from humidity. ³⁄₄" (19.1 mm) * This dimension is for 4" (10.2 cm) toe kick. If the installation needs a higher toe kick, adjust the height of the wood panel accordingly. Not recommended for toe kicks greater than 6" (15.2 cm). With a TORX® screwdriver, remove three screws from both sides, as shown; hold the outer panel up while removing the screws. Save screws for reinstallation. 2 Custom panel dimensions- Dishwashers with control panel on the top 3 screws per side outer panel Gently set outer panel aside. Lay the customer-supplied custom panel face down on a covered, non-scratching surface. 15