KitchenAid KUDE45CVBL Installation Instructions - Page 10
Install Drain Hose
View all KitchenAid KUDE45CVBL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Install Drain Hose IMPORTANT: Always use a new drain hose. Check local codes to determine whether an air gap is required. 1 Drill hole Option A, Waste disposer - no air gap Waste disposer - no air gap Disposer inlet Large silver drain hose clamp Drain hose 1¹⁄₂" (3.8 cm) Drain trap 1 1. Using a hammer and screwdriver, knock plug into disposer. If needed, drill a 1¹⁄₂" (3.8 cm) diameter hole in cabinet wall or side of the opening closest to the sink. 2 Route drain hose Drain hose Route drain hose as shown through hole in cabinet to the front center of opening where drain connection will be made. Tape drain hose to the floor in area shown. This will prohibit it from moving when dishwasher is moved into cabinet opening. 3 Connect drain hose Connect drain hose to waste tee or waste disposer using one of the following options: • Option A, Waste disposer - no air gap • Option B, No waste disposer - no air gap • Option C, Waste disposer - with air gap • Option D, No waste disposer - with air gap IMPORTANT: The drain hose connection of the disposer or a waste tee must be made before the drain trap and at least 20" (50.8 cm) above the floor where the dishwasher will be installed. Helpful Tip: To reduce vibration of the hose, keep the hose away from the floor. 2 2. Use needle-nose pliers to remove plug. 3 3. Attach drain hose to disposer inlet with large silver drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. Option B, No waste disposer - no air gap No waste disposer - no air gap SLcarregwe-tsyilpveer drainchlaomsep clamp Waste tee Drain hose Drain trap 1 Black end 2 1. Connect black end of of drain hose to waste tee and cut if needed. (Do not cut ribbed section.) 2. Attach black end of drain hose to waste tee with a large silver drain hose clamp (provided). Use pliers to squeeze clamp open and move into position. If the drain hose was cut, use a 1¹⁄₂" to 2" (3.8 to 5 cm) screw-type clamp (not provided). 10