KitchenAid KUDE60FVBL Installation Instructions - Page 17
Choose Attachment Option
UPC - 883049157788
View all KitchenAid KUDE60FVBL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
2 Dishwashers with control panel on front custom panel dimensions 3 screws per side outer panel Gently set outer panel aside. Lay the cutomer-supplied custom panel face down on a non-scratching surface. Position the outer panel on the back of the customersupplied custom panel as shown; make sure top edge of the outer panel is aligned with the top edge of the customer-supplied custom panel, and both panels are centered side to side. 3 Mark pilot holes Mark pilot holes Mark all four hole locations; remove outer panel and drill 3/32" pilot holes 1/2" (13 mm) deep, in customer-supplied custom panel. Place the outer panel on the back of the customer-supplied custom panel and align holes. Attach outer panel to back of customer-supplied custom panel with four #10 x 1/2" wood screws (not supplied). If the customer-supplied custom panel is less than 3/4" (1.9 cm) thick where the screws are attached, shorter screws maybe required. 4 Attach body panel Reinstall 3 screws each side Align top edges Customer-supplied panel Choose Attachment Option WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. Using two or more people, stand the dishwasher up. Option 1, Countertop attachment: Countertop attachment brackets IMPORTANT: The dishwasher must be secured to the cabinet. There are two brackets on top of the dishwasher that can be attached to the countertop if it is wood, laminate or other similar surfaces. If your countertop is marble, granite or other hard surface the brackets may be moved to the sides of the dishwasher. NOTE: Do not attach the dishwasher. This will be done later. Option 2, Dishwasher side attachment: 1 Remove brackets from the top tabs To remove the brackets from the top, flatten tab at back of brackets with pliers, and pull the brackets out of the slots. Attach the panel assembly to the door by reinstalling the three screws on each side. 17