KitchenAid KUDS30IVBT Installation Instructions - Page 18

2 Break end of bracket score line Break off the end of the bracket along the scored line. With another person holding the rear of the dishwasher to keep it from tipping, open dishwasher door and place towel over pump assembly and spray arm of dishwasher. This will keep screws from falling into pump area when you are securing dishwasher to cabinet. 3 Insert plastic buttons Move Dishwasher into Cabinet Opening WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. 1 Stand dishwasher upright plastic button Push the plastic buttons out of the side of the tub. NOTE: Save the buttons to cover the holes after dishwasher is installed. 4 Reinstall bracket bend tabs Push bracket into slot on the side of dishwasher, and bend tab in toward the side of the dishwasher so that it keeps the bracket in place. Repeat this step for the other side of the dishwasher. NOTE: Do not attach the dishwasher. This will be done later. Using two or more people, stand dishwasher upright. NOTE: Do not install kickplate until instructed. 2 Move dishwasher close to cabinet opening Drain hose Water line Cable Direct wire only IMPORTANT: Double check correct placement of utilities. Grasp the sides of the dishwasher at the edges of the door panel. Tilt dishwasher backwards on wheels and move dishwasher close to cabinet opening. NOTE: Do not push on the front of the panel or on the console. Panel or console may dent. Helpful Tip: Temporarily tape utilities to the floor in the locations shown to prohibit them from moving when dishwasher is moved into the cabinet opening. 18