KitchenAid KUDS35FXSS Installation Guide - Page 3
Installation Requirements - install guide
UPC - 883049218120
View all KitchenAid KUDS35FXSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
INSTALLATION REQUIREMENTS Tools and Parts Gather the recommended tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. All Installations Tools needed: Pliers Flat-blade screwdriver Phillips screwdriver Utility knife " " nut drivers or hex sockets Measuring tape or ruler UL Listed/CSA Approved twist-on wire connectors* Small level 10" adjustable wrench that opens to " " wrench If installing custom front panels, Torx®† T15 screwdriver *Must be the proper size to connect your household wiring to 16-gauge wiring in dishwasher Other useful items you may need: Flashlight Bath towel Supplied in Kit: 4 Plastic studs (attached to each other by runners) 4 Short screws (10-16 hex head screw) 4 Long screws (8-18 Torx®† head screws) 1 Template (located inside Use and Care Guide bag assembly) 1 Instruction sheet (located inside Use and Care Guide bag assembly) NOTE: The screws supplied are used for only ³⁄₄" thick wooden panel. If the wooden panel is less than ³⁄₄" thick, customer must purchase screws locally. Other parts you may also need: (3.81-5 cm) Screw-type clamps (3 maximum) Masking or Moisture duct tape barrier tape (Part Number 4396277). NOTE: Moisture barrier tape is recommended when installing a dishwasher under a wood countertop. NOTE: Parts available for purchase in plumbing supply stores. Check local codes. Check existing electrical supply. See "Electrical Requirements" section. It is recommended that electrical connections be made by a licensed electrical installer. In addition, for first-time installations Tools needed: Cordless drill with and 1¹⁄₂" hole saw bits Small tubing cutter Wire stripper Shallow pan Wood block Parts supplied: Drain hose Drain hose 2 - under- 2 - clamps (2) Phillips- counter custom (1 large and head mounting tape 1 small) screws (2) brackets (top) Parts needed: Copp O.D. suggested) or flexible braided water supply line See "Electrical Requirements" section. For Direct Wire: use UL Listed/ CSA Approved strain relief hole For Power Supply Cord: use UL Listed/CSA Approved power supply cord kit marked for use with dishwasher MSailkveersuGrreeaelnl these parts are included in the literature package. Parts needed: Additional parts supplied with top-venting models only: " Torx® T15 screws " 4 #10 x ¹⁄₂" wood screws (if installing custom front panels) †® TORX is a registered trademark of Saturn Fasteners, Inc. Additional parts supplied with certain models only: Bottom sound pad (located in lower rack) Make sure all these parts are included in the literature package. If parts are not included, call 1-800-422-1230. 3