KitchenAid KUDT03STBL Installation Instructions - Page 10
Warning
View all KitchenAid KUDT03STBL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Prepare dishwasher WARNING Tip Over Hazard Do not use dishwasher until completely installed. Do not push down on open door. Doing so can result in serious injury or cuts. WARNING Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. 1. Put corner posts from packaging behind dishwasher. Grasp sides of dishwasher door frame and put dishwasher on its back, resting on top of the corner posts. 2. Remove two screws attaching access panel and lower panel to dishwasher using a 1/4" hex socket, nut driver or Phillips screwdriver. access panel lower panel grounding clip 3. Remove panels and set panels aside on a protective surface. 4. Check that grounding clip is attached to the lower panel. 5. Apply Teflon® tape or pipe joint compound to 90° elbow fitting and connect fitting to water inlet valve. 6. Tighten elbow until snug, and be sure that it faces to the rear. water inlet valve elbow 7. Remove terminal box cover. - If you are direct wiring: install a U.L.-listed/CSAcertified clamp connector to the terminal box. If using conduit, use a U.L.-listed/CSA-certified conduit connector. - If you are installing a power supply cord kit, do so now, following kit instructions. terminal box cover ADVERTENCIA AVERTISSEMENT dishwasher wires cable clamp connector Helpful Tip: Put cardboard under dishwasher until it is installed in cabinet opening. The cardboard will help protect floor covering during installation. 8. Measure height of cabinet opening from underside of countertop to floor where dishwasher will be installed (you need the lowest point). Check chart for that height opening. Put wheels in the required position. wheel 1 Minimum cutout height Wheel position Number of turns on front leg 2 34" (86.4 cm) 1 10 3 34-1/4" (87 cm) 2 5 34-1/2" (87.6 cm) 3 0 9. Turn both front leveler legs to the same height. If the minimum cutout height is less than 34" (86.4 cm), the rear wheels can be removed for additional clearance. This will allow the dishwasher to fit into a 33-7/8" (86 cm) high cutout, but the dishwasher will be more difficult to move into position. If the wheels are removed, protect the floor when moving the dishwasher. front leg If you have built-up floors 1. Measure height of opening from underside of countertop to built-up floor. If the height is at least 33-3/4" (85.7 cm), the dishwasher will fit into the opening without modification to the countertop or flooring. 2. Put wheels in position 1 and turn the front leveler legs up shim all the way. countertop 33-3/4" (85.7 cm) min. built-up floor 10