KitchenAid KXU2836JSS Installation Instructions - Page 4

INSTALLATION REQUIREMENTS Tools and Parts Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed ■ Level ■ Drill 3 mm) drill bit 19 mm) drill bit ■ Pencil ■ Pliers ■ Wire stripper or utility knife ■ Tape measure or ruler ■ Caulking gun and weatherproof caulking compound ■ Phillips screwdriver ■ Flat-blade screwdriver ■ T-10 TORX®† driver ■ Saber or keyhole saw ■ Vent clamps ■ Metal snips Parts needed ■ Home power supply cable ■ Two ¹⁄₂" (1.3 cm) UL listed or CSA approved strain reliefs ■ 3 UL listed wire connectors For vented installations, you will also needed: ■ 1 wall or roof cap ■ Metal vent system For non-vented (recirculating) installations, you will also need: ■ Recirculation Kit Part Number W10356918. See the "Assistance or Service" section to order. Optional parts needed: ■ Wood filler strips for cabinets with recessed bottoms. Length and thickness determined by recess dimensions. See the "Prepare Location" section. ■ Two, 1" x 1" x 5" (25 x 25 x 12.7 cm) wood pieces for cabinet floor. See the "Prepare Location" section. ■ Four, 1¹⁄₄" (3.2 cm) wood screws Parts supplied Remove parts from packages. Check that all parts are included. ■ Damper: Part Number W10369162 ■ Hardware package: Part Number W10369160. Includes: Installation Instructions and Use and Care Guide 2 lower leveling brackets 2 upper leveling brackets 2 - 2.5 x 9.5 mm metal screws 4 - 4.5 x 16 mm wood screws 4 - 5 x 18 mm machine screws 4 - 3.5 x 9.5 mm metal screws †®TORX is a registered trademark of Saturn Fasteners, Inc. 4 Location Requirements IMPORTANT: Observe all governing codes and ordinances. Have a qualified technician install the range hood. It is the installer's responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located behind the filter on the left rear wall of the range hood. Range hood location should be away from strong draft areas, such as windows, doors, and strong heating vents. Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance. Consult your cooktop/ range manufacturer installation instructions before making any cutouts. Grounded electrical outlet is required. See "Electrical Requirements" section. The range hood is factory set for vented installations through the roof or wall. For non-vented (recirculating) installations see "NonVented (recirculating) Installation Through the Soffit/Cabinet" in the "Prepare Location" section. Recirculation Kit Part Number W10356918 is available from your dealer or an authorized parts distributor. All openings in ceiling and wall where range hood will be installed must be sealed. For Mobile Home Installations The installation of this range hood must conform to the Manufactured Home Construction Safety Standards, Title 24 CFR, Part 328 (formerly the Federal Standard for Mobile Home Construction and Safety, title 24, HUD, Part 280) or when such standard is not applicable, the standard for Manufactured Home Installation 1982 (Manufactured Home Sites, Communities and Setups) ANSI A225.1/NFPA 501A*, or latest edition, or with local codes.