KitchenAid RKV25G0XER Owners Manual 1 - Page 10
Using the Pouring Shield
View all KitchenAid RKV25G0XER manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Auto-Reset Motor Protection If the stand mixer does not restart, If the stand mixer stops due to overload, slide the speed control see the "Troubleshooting Problems" section. lever to OFF. After a few minutes, the stand mixer will automatically reset. Slide the Speed Control Lever to the desired speed and continue mixing. Using the Pouring Shield* Attaching the Pouring Shield* 1. Make sure the speed control lever is set to the OFF/0 position. 2. Unplug the stand mixer. 3. Attach desired accessory and raise the mixing bowl. 4. Slide pouring shield collar around beater shaft, centering collar over rim of bowl. Using the Pouring Shield Pour ingredients into the mixing bowl through the chute portion of shield. IMPORTANT: Make sure the guides on the bottom of the chute rest on the rim of the bowl to keep ingredients from falling outside the bowl as they are added. Pouring Chute Removing the Pouring Shield 1. Make sure the speed control lever is set to the OFF/0 position. 2. Unplug the stand mixer. 3. Remove pouring chute from collar. 4. Slide pouring shield collar off bowl. 5. Lower the bowl support by turning the bowl-lift lever clockwise. 6. Remove accessory and the mixing bowl. Cleaning the Pouring Shield Wash in warm sudsy water. If you wish, you may place on the top rack of your dishwasher. *If Pouring Shield is included. 10