KitchenAid UXB0600DYS Installation Guide - Page 11
Range Hood Care - dishwasher
View all KitchenAid UXB0600DYS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Range Hood Controls A B C D E A. On/Off light button B. Blower Off button C. Blower speed minimum button D. Blower speed medium button E. Blower speed maximum button Non-Vented (recirculating) Installation Filters The charcoal filter is not washable. It should last up to six months with normal use. Replace with Charcoal Filter Kit Number W10272068. To replace charcoal filter: 1. Cover the grille that covers the blower motor with the charcoal filter so that the slots on the filter correspond to the pins on the sides of the motor cover grille. Operating the light The On/Off light button controls both lights. Press once for On and again for Off. Operating the blower The Blower Speed buttons turn the blower on and control the blower speed and sound level for quiet operation. The speed can be changed anytime during fan operation by pressing the desired blower speed button. The Blower Off button turns the blower Off. RANGE HOOD CARE Cleaning IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace grease filters before operating hood. Exterior Surfaces: To avoid damage to the exterior surface, do not use steel wool or soap-filled scouring pads. Always wipe dry to avoid water marks. Cleaning Method: ■ Liquid detergent soap and water, or all-purpose cleanser ■ Wipe with damp soft cloth or nonabrasive sponge, then rinse with clean water and wipe dry. Metal Grease Filters 1. Remove each filter by pulling the spring release handle and then pulling down the filter. AB C A. Charcoal filter B. Pins C. Blower motor 2. Turn the charcoal filter clockwise to lock it. 3. Repeat steps 1-2 on the other filter. Replacing a Halogen Lamp Turn off the range hood and allow the halogen lamp to cool. To avoid damage or decreasing the life of the new lamp, do not touch lamp with bare fingers. Replace lamp, using tissue or wearing cotton gloves to handle lamp. If new lights do not operate, make sure the lamps are inserted correctly before calling service. 1. Disconnect power. 2. Use a flat-blade screwdriver and gently pry the light cover loose. A A. Spring release handle 2. Wash metal filters as needed in dishwasher or hot detergent solution. 3. Reinstall the filter by making sure the spring release handles are toward the front. Insert aluminum filter into upper track. 4. Push in spring release handle. 5. Push up on metal filter and release handle to latch into place. 6. Repeat steps 1-5 for the other filter. 3. Remove the lamp and replace with a 120-volt, 40-watt maximum, halogen lamp made for a G-9 base. 4. Replace the light cover. 5. Reconnect power. 11