Kodak Esp-3 Setup Booklet - Page 13

Safety Information - Read and follow these instructions before using KODAK products. - Always follow basic safety procedures. - Follow all warnings and instructions marked on the equipment. WARNING STATEMENTS - Do not expose this product to liquid, moisture, or extreme temperatures. KODAK AC adapters are intended for indoor use only. The use of controls, adjustments, or procedures other than those specified herein may result in exposure to shock and/or electrical or mechanical hazards. - Keep ink cartridges out of reach of children. Ink may be harmful if swallowed. - Do not place your All-in-One Printer on an unstable cart, stand, bracket, or table. Injury to persons and damage to the equipment may occur. - The use of an accessory attachment that is not recommended by Kodak, such as an AC adapter, may cause fire, electric shock, or injury. - Pushing objects through the equipment openings can result in an electric shock or risk of fire. CAUTIONARY STATEMENTS - Adjust only those controls covered in the operating instructions. - Do not disassemble this product; there are no user-serviceable parts inside. Refer servicing to qualified service personnel. - The AC adapter power supply is equipped with 3-wire grounding type plugs. If you cannot insert the plug into the power outlet, contact an electrician to check or replace the power outlet. - Do not plug the AC adapter into a household extension cord. - If the power cord or plug is frayed or damaged, the equipment gets wet, or the equipment does not operate normally when the operating instructions are followed, unplug your All-in-One Printer from the power outlet and contact Kodak qualified service personnel for further instructions. - For added protection from damage during a lightning storm, or any time when your All-in-One Printer and it's associated AC adapter will be left unused for long periods of time, unplug the AC adapter from the power outlet and any attached fax line from the printer. - To prevent your All-in-One printer from overheating do not place it near a heat register, or install it in a cabinet without proper ventilation. - Do not use your All-in-One Printer near water or spill liquid on it. - Unplug the equipment from the wall outlet before cleaning. - Dropping your All-in-One Printer may damage the housing and result in extensive damage that will require repair by a qualified technician to restore normal operation. - Excessive dust levels may damage internal parts. For more information, go to www.kodak.com/go/MSDS www.kodak.com/go/aiosupport 13