Kodak I610 User Guide - Page 27
Image calibration, Kodak Scanner: i600 - scanner maintenance
UPC - 041771485610
View all Kodak I610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Image calibration Use the calibration target provided with your scanner. Be sure to use a good, clean calibration target. Additional calibration targets can be ordered. See Chapter 5, "Supplies and accessories" for ordering information. NOTE: The screens shown in this section are for the TWAIN Datasource. The screens displayed on your system may be different. 1. Open the pod and clean the imaging guides. Refer to the maintenance procedures in Chapter 5. 2. If the lamps have not been on, allow the lamps to warm up for 90 seconds. 3. Center the side guides in the elevator tray and output tray. 4. Place the calibration target in the elevator tray. 5. Open the Scan Validation Tool. 6. Select Kodak Scanner: i600 or Kodak Scanner: i700. The main Kodak Scanner window will be displayed. 3-12 A-61500 April 2009