Konica Minolta 3D Cube Printer Cube3 Quick Start Guide - Page 27
Maintenance
![]() |
View all Konica Minolta 3D Cube Printer manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
MAINTENANCE PRINT PAD MAINTENANCE Auto Level and Auto Gap can be affected by a residual glue or print material adhered to the print pad. These procedures can also be affected by a print pad that is too shiny. 1. Select PLATE MAINTENANCE. 2. Remove the print pad. NOTE: The print pad is magnetically attached to the adjustment knobs. 3. Using the fine-grit sandpaper, buff the print pad. NOTE: Refer to the section titled Clean The Print Pad for specific instructions. NOTE: Ensure the print pad is clean and dry before installing it in the printer. 4. Select the checkmark to continue. 5. Perform the Auto Level and Auto Gap procedures. 24
![](/manual_guide/products/konica-minolta-cube-cube3-quick-start-guide-e7fbdcb/27.png)
24
MAINTENANCE
PRINT PAD MAINTENANCE
Auto Level and Auto Gap can be affected by a residual glue or print material adhered to the print pad.
These procedures can also be affected by a print pad that is too shiny.
1.
Select
PLATE MAINTENANCE
.
2.
Remove the print pad.
NOTE: The print pad is magnetically attached to
the adjustment knobs.
3.
Using the fine-grit sandpaper, buff the print pad.
NOTE: Refer to the section titled Clean The Print
Pad for specific instructions.
NOTE: Ensure the print pad is clean and dry
before installing it in the printer.
4.
Select the
checkmark
to continue.
5.
Perform the Auto Level and Auto Gap procedures.