Konica Minolta Kodak i750 User Guide - Page 12
Making connections, Installing the IEEE-1394 card in the host computer
View all Konica Minolta Kodak i750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Making connections Installing the IEEE-1394 card in the host computer Installing the Kodak Driver software Installing the FireWire cable Follow the instructions for installing the IEEE-1394 (FireWire) card and the Kodak driver software before you plug the scanner into the host computer. IMPORTANT: You must install the software on the host computer before you connect the scanner. Install the IEEE-1394 (FireWire) card according to the directions supplied with the IEEE-1394 card. IMPORTANT: Use proper precautions to avoid static when you install the IEEE-1394 card in your computer. Make sure the computer power cord is disconnected. 1. Insert the installation CD in the CD-ROM drive. The installation program starts automatically. 2. Follow the on-screen instructions to install the TWAIN Datasource, ISIS Driver and the Kodak Scan Validation Tool. 3. Shut down the host computer. An IEEE-1394 six-pin connector is provided on the rear panel of the scanner for IEEE-1394 connectivity. 1. Plug the end of the cable with the right angle into the scanner. 2. Connect the other end of the cable into the IEEE-1394 card outlet in the host computer. Be sure that it is installed correctly and properly seated. CAUTION: DO NOT FORCE THE CONNECTOR. If the cable is not properly connected, it could cause damage to the scanner. 2-2 A-61500 May 2010