Konica Minolta bizhub 25 Barcode OCR Font Setting Manual - Page 14

Precautions for Use, Important, 8-bit Code and Control Code, Start/Stop/Check Digit - toner

Page 14 highlights

Precautions for Use Important ••This barcode can only be used with PCL5e. ••In order to correctly print and use the barcode font, the application software must support the barcode font. ••It may not be possible to read the printed barcode with all scanners due to variations in toner density and paper quality, therefore we recommend that you verify the reading ability of the scanner before use. 8-bit Code and Control Code In order assign the PCL5 command and barcode data character strings, hexadecimal digits (00 to 1F) control code and 8-bit code (AA, etc.) must be assigned. The use of "~" (tilde) instead of and expressing the control code with ASCII character strings by the **#J (Alternate Escape Code) command is not supported. Start/Stop/Check Digit Start, Stop and guard bar must be assigned as a character string while being aware of the Barcode type. The user must knowingly insert the spaces around the Barcode. Also, the check digit should be calculated manually from the data that is going to be expressed based on the barcode code and the check digit must be inserted into the correct position of the data character string. (Generally before the Stop character.) Caption Caption input is not supported. The user must insert captions as a PCL5 command. 14 Precautions for Use

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14

14
Precautions for Use
Precautions for Use
Important
This barcode can only be used with PCL5e.
In order to correctly print and use the barcode font, the application software must
support the barcode font.
It may not be possible to read the printed barcode with all scanners due to variations
in toner density and paper quality, therefore we recommend that you verify the reading
ability of the scanner before use.
8-bit Code and Control Code
In order assign the PCL5 command and barcode data character strings, hexadecimal
digits (00 to 1F) control code and 8-bit code (AA, etc.) must be assigned. The use of "~" (tilde)
instead of <ESC> and expressing the control code with ASCII character strings by the
<ESC>**#J (Alternate Escape Code) command is not supported.
Start/Stop/Check Digit
Start, Stop and guard bar must be assigned as a character string while being aware of the
Barcode type. The user must knowingly insert the spaces around the Barcode.
Also, the check digit should be calculated manually from the data that is going to be
expressed based on the barcode code and the check digit must be inserted into the correct
position of the data character string. (Generally before the Stop character.)
Caption
Caption input is not supported. The user must insert captions as a PCL5 command.