Konica Minolta bizhub C552DS bizhub C452/C552/C552DS/C652/C652DS Copy Operatio - Page 211
Loading paper into trays 3 and 4
View all Konica Minolta bizhub C552DS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 211 highlights
8.1 Paper 8 Loading paper into trays 3 and 4 The same procedures can be used to load paper into trays 3 and 4. The following procedure describes how to load paper into tray 3. 1 Pull out tray 3. NOTICE Be careful not to touch the surface of the paper take-up roller with your hand. 2 Lift up the paper take-up roller, and then load the paper into the tray. % Load the paper into the tray so that the side of the paper to be printed on (the side facing up when the package was unwrapped) faces up. % Do not load so many sheets of paper that the top of the stack is higher than the mark. % Do not load tray 3 with paper of a size other than that previously specified. % If paper is curled, flatten it before loading it. % If special paper is loaded, the paper type must be specified. % Load letterhead paper so that the side to be printed on faces down. % To change the paper size for tray 3, contact your service representative. 3 Lower the paper take-up roller, and then close tray 3. d Reference To configure paper settings: Press [Basic] ö [Paper]. bizhub C652/C652DS/C552/C552DS/C452 8-4