Konica Minolta bizhub PRESS C1070/1070P IC-308/IC-310/IC-415 Ver 2.1 Addendum - Page 3

3 Install Fiery Driver version 4.8 with Point and Print After Fiery Color Server version 2.1 software is installed on the Fiery Color Server, you can download and install the printer driver on the client computer with Point and Print. You can then print to a particular connection (Print queue, Hold queue, Direct connection, or Sequential Print queue). 1 On the client computer, select Start > Run and then type \\, where IP address is the address of the Fiery Color Server. For example, type \\10.10.10.10, and then press Enter on the keyboard. The printer drivers for the following print connections are shown: • Hold • Print • Direct • Sequential 2 Double-click the printer driver that you want to install. Each connection requires a separate installation. Repeat the procedure for each connection. Addendum to the Printing Guide This chapter describes additions and corrections to Printing to describe the new features in Fiery Color Server version 2.1 software. The following new features and print options are supported in version 2.1: • Fold: Spine formed half fold setting (Job Properties Finishing tab) • Staple: Center 2 position and Center 4 position settings available with the SD-513 finisher • Crease print option (Job Properties Finishing tab) • Slit print options (Job Properties Finishing tab) • Free Crease web application • Fiery JDF feature for Fiery® ES IC-415 Note: To use the new print options, the Saddle Stitch Unit (SD-513 finisher) must be installed. For information about Fiery Color Server support for installing finishers and other installable options, see the printer driver help. Software support for the Saddle Stitch Unit (SD-513 finisher) The Fiery Color Server version 2.1 software supports the Saddle Stitch Unit, SD-513 finisher, for saddle-stitch printing, which can be used with the creaser, slitter, and spine corner form options. The following print options are associated with the SD-513 finisher and are available on the Finishing tab in Job Properties, which can be accessed either from the printer driver or Command WorkStation. Fold: Spine formed half fold (square fold) print option is used to compress the spine edge of your booklet print job. This option requires a 5-sheet minimum.