Kyocera ECOSYS FS-1320D Kyocera Command Center Operation Guide Rev 6.5.2012.7 - Page 52
Advanced > Management > SNMP > SNMPv3, Trap IP Address IPv6
View all Kyocera ECOSYS FS-1320D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
COMMAND CENTER Pages SNMPv1/v2c Sets whether to use the SNMPv1/v2c protocol. Set On to use it. After you have changed the setting, you must restart the printing system. Read Community Enter the community name for SNMP requests to read a value. The default name is 'public'. After you have changed the setting, you must restart the printing system. Write Community Enter the community name for SNMP requests to write (change) a value. The default name is 'public'. After you have changed the setting, you must restart the printing system. sysContact The MIB-II sysContact object. Usually this is the E-mail address of the network administrator. sysName The MIB-II sysName object. Usually this is the host or domain name of the printing system. sysLocation The MIB-II sysLocation object. Usually this is the location information of the printing system. HP Web Jetadmin Compatibility Turns HP Web Jetadmin Compatibility On or Off. After you have changed the setting, you must restart the printing system. Authentication Traps Specifies whether to use authentication traps. If enabled (On), an SNMP trap is generated when an attempt to read or write is made using an incorrect community name. The trap is sent to the configured trap address. After you have changed the setting, you must restart the printing system. Trap Community The SNMP trap community name to be used when the printing system generates a trap. Trap IP Address (IPv4) Enter the IPv4 address that receives traps. Select On to enable trap receiving. Trap IP Address (IPv6) Enter the IPv6 address that receives traps. Select On to enable trap receiving. Trap IPX Address Enter the IPX address that receives traps. Select On to enable trap receiving. Selected Errors Select the events which will cause a trap to be generated from Add Paper, Low Toner, Add Toner, Cover Open, Paper Jam, and All Other Errors. Advanced > Management > SNMP > SNMPv3 The section below provides a summary of the items displayed on the SNMPv3 page. After you have changed the setting, you must restart the printing system. SNMPv3 Sets whether to use the SNMPv3 protocol. Set On to use it. Authentication 3-45 User Guide