Kyocera ECOSYS FS-4020DN FS-2020D/3920DN/4020DN Operation Guide (Basic) - Page 38
Connections, Connecting the USB Cable
View all Kyocera ECOSYS FS-4020DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Connections This section explains how to start up the printer. The figure shown below is the overviews of connections between the printer and the computer. Connecting the USB Cable Follow the steps as below for connecting the USB cable. 1 Connect the USB cable (not included) to the USB interface connector at the rear of this machine. Note Use a USB cable with a rectangular Type A plug and a square Type B plug. The USB cable should be shielded and no longer than 5 meters (16 feet) long. 2 Connect the other end of the USB cable to the computer's USB interface connector. Connecting the Network Cable Follow the steps as below for connecting the network cable. 1 Remove the cap and connect the shielded network cable (not included) to the computer and the hub (concentrator). 2 Connect the other side of the network cable to the network interface connector at the rear of this machine and the hub. Connecting the Parallel Cable Follow the steps as below for connecting the parallel cable. 1 Connect the parallel cable to the parallel interface connector at the rear of this machine. Note Use a parallel printer cable that complies with IEEE 1284 standards. For optimum performance, install the printer close to the PC. The connection cable should be shielded and no longer than 3 meters (10 feet) long. The cable is solid separately. 2 Connect the other side of the parallel cable to the computer's interface connector at the rear of this machine. 3-2 Connecting and Printing