Kyocera ECOSYS M6035cidn PCL Barcode Flash 3.0 User's Manual Rev 3.2.03.2013 - Page 42
Syntax in PRESCRIBE
View all Kyocera ECOSYS M6035cidn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Syntax in PRESCRIBE If you are not confident with programming in PRESCRIBE, we recommend that you read the "PRESCRIBE IIE PROGRAMMING MANUAL". The BARC command is used. The syntax described in the PRESCRIBE manual for the BARC command is valid for the one-dimensional barcodes supported. As you will see below, the syntax for two-dimensional barcodes is slightly different. The following parameters exist, all of which - except the "Barcode type" parameter - are optional. If these are entered, they must be separated by commas. Barcode type, identity number for Datamatrix 100 Module size The unit of module size is preceded by the UNIT command. We recommend that you use dots (pixels) => UNIT D;. Lowest symbol number Values from 1 to 30. To understand what this parameter means, compare the explanations for the h parameter in the section entitled "Syntax in PCL". Highest symbol number Values from 1 to 30. To understand what this parameter means, compare the explanations for the h parameter in the section entitled "Syntax in PCL". Type of coding 0 must always be entered. Error correction level 0 must always be entered. Amount of base data in bytes The base data can be passed in three different ways. 42