Kyocera ECOSYS P6130cdn PRESCRIBE Commands Technical Reference Manual - Rev. 4 - Page 102
Interface-dependent Parameters
View all Kyocera ECOSYS P6130cdn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 102 highlights
Chapter 6 Permanent Parameters FRPO Parameters The FRPO command changes the value of one parameter in permanent memory. A separate command is required for each parameter change. The parameters, their meanings, and the specifiable values are listed below. In these tables, the Interface-dependent parameters affect the environment on the current interface only. Any changes made to the parameters on one interface will not change parameters on the other interfaces. To change a similar parameter on another interface, first switch to that interface then issue the FRPO command. The Interface-independent parameters affect all interfaces simultaneously. If the printing system is shared with other users, remember that changes made to non-interfacedependent parameters can affect users on other interfaces as well. Certain parameters are available only when the printing system is installed with the relevant option equipment. Note Interface-dependent Parameters Table 6.1. Interface-dependent Parameters (Sheet 1 of 3) Environment Top margina Left margina Page lengtha Page widtha Page orientationa Default font No.a Operation panel settings saving PCL font rangec KC-GL optionsa Parameter A1 A2 A3 A4 A5 A6 A7 A8 C1 C5 C2 C3 C6 C8 G0 Value Factory setting Integer value in inches 0 Fraction value in 1/100 inches 0 Integer value in inches 0 Fraction value in 1/100 inches Integer value in inches Fraction value in 1/100 inches Integer value in inches Fraction value in 1/100 inches 0 13 (17)b 61 (30)b 13 (17)b 61 (30)b 0: Portrait, 1: Landscape 0 First two digits of power-up font 00 Middle two digits of power-up font 00 Last two digits of power-up font 00 0: Not saved at power-off 1 1: Saved at power-off 0: HP compatibility mode (Characters higher 0 than 127 are not printed.) 32: Conventional mode (Characters higher than 127 are printed. Supported symbol sets: ISO-60 Norway [00D], ISO-15 Italian [00I], ISO-11 Sweden [00S], ISO-6 ASCII [00U], ISO-4 U.K. [01E], ISO-69 France [01F], ISO-21 Germany [01G], ISO-17 Spain [02S], Symbol [19M]c) 0: Mode A; formfeed to SP0 0 1: Mode B; formfeed to SP0 2: Mode A; no formfeed to SP0 3: Mode B; no formfeed to SP0 4: Fixed mode A; formfeed 5: Fixed mode B; formfeed 6: Fixed mode A; no formfeed 7: Fixed mode B; no formfeed 8: Mode A; formfeed 9: Mode B; formfeed 10: Mode A; no formfeed 11: Mode B; no formfeed 12: Fixed mode A; formfeed 13: Fixed mode B; formfeed 14: Fixed mode A; no formfeed 6-2