Kyocera ECOSYS P8060cdn Kyocera Command Center RX User Guide Rev-9.2016.6 - Page 101
Notification/Report, Notification/Report Settings
View all Kyocera ECOSYS P8060cdn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Management Settings 3. Configure the ID Card Settings. Select IDM or FeliCa as the ID Card Read Type. 4. Configure the FeliCa Settings. System Code 1 Enter the System Code 1 from 0000 to FFFF. Service Code 1 Enter the Service Code 1 from 0000 to FFFF. Number of Blocks in Use. Enter the number of blocks in use from 1 to 255. System Code 2 Enter the System Code 2 from 0000 to FFFF. Service Code 2 Enter the Service Code 2 from 0000 to FFFF. Number of Blocks in Use. Enter the number of blocks in use from 1 to 255. Configure the System Code 2 as necessary. 5. Click Submit button. Notification/Report This section includes advanced settings for attentions and reports. Notification/Report Settings 1. Click Notification/Report under Management Settings on the navigation menu. The Notification/Report Settings page opens. 2. You can configure settings for Management Report. This item is shown only when an optional Fax kit is installed. Outgoing FAX Report Select either On or Off. Incoming FAX Report Select either On or Off. 3. You can configure settings for Send Result Report. E-mail/Folder From the drop-down list, select Off, On, or Error Only. If an error occurs during transmission, Error Only allows a transmission result reported by e-mail and stored in the folder. User Guide 97