Kyocera FS-1320D PRESCRIBE Commands Technical Reference Manual - Rev. 4.7 - Page 63
Macros
UPC - 632983018194
View all Kyocera FS-1320D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Chapter 3 Macros After you have gone to the trouble of creating (and debugging) a PRESCRIBE command sequence, it is inefficient to use it only once, but it is a nuisance to type the same sequence repeatedly. The solution is to make the sequence into a macro. Then you can execute the entire sequence with a single CALL command. The procedure for defining a macro command sequence is simple. Step 1:Assign a name to the sequence. Place the name at the top of the sequence (ending with a semicolon). Step 2:Add the PRESCRIBE command MCRO in front of the name. Step 3:Add the PRESCRIBE command ENDM at the end of the sequence.
Chapter 3
Macros
After you have gone to the trouble of creating (and debugging) a PRESCRIBE command
sequence, it is inefficient to use it only once, but it is a nuisance to type the same
sequence repeatedly. The solution is to make the sequence into a macro. Then you can
execute the entire sequence with a single CALL command. The procedure for defining a
macro command sequence is simple.
Step 1:Assign a name to the sequence. Place the name at the top of the sequence (ending
with a semicolon).
Step 2:Add the PRESCRIBE command MCRO in front of the name.
Step 3:Add the PRESCRIBE command ENDM at the end of the sequence.